Installation guide

Complete installation
1. Check that grounding clip is attached to the lower
panel.
2. Place the lower panel behind the access panel. Some
models have insulation on the access panel which must
fall behind the insulation on the lower panel.
grounding
clip
3. Hold the two panels together and place them against
dishwasher leg.
4. Reinstall the screws through the holes in the access
panel and the slots in the lower panel. Install right side
screw first.
j J"
/
/
/
5. Check that the lower edge of the lower panel contacts
the floor.
6. Tighten the screws.
Direct wire method:
Electrical Shock Hazard
Electrically ground dishwasher.
Connect ground wire to green ground connector in
terminal box.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Power supply cord method:
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
7, Reconnect power or plug in dishwasher.
Check operation
1.
2.
3.
4.
5.
6.
Read the Use and Care Guide that came with your
dishwasher.
Check that all parts have been installed and no steps
were skipped.
Check that you have all the tools you used.
Start dishwasher and allow it to complete the shortest
wash cycle. After the first two minutes, unlatch door,
wait five seconds, then open door.
Check to see that there is water in the bottom of the
dishwasher tub. Check that dishwasher is working
properly.
If not, disconnect power or unplug dishwasher and see
"If dishwasher does not operate" section.
14