Instruction for Use

5
3. HOW TO USE THE APPLIANCE
HOW TO LOAD THE RACKS
CUTLERY RACK:
May be used in two different positions.
In position 2 the upper rack must be
lowered (see “Upper rack height
adjustment”
C
below).
For optimum washing results, position
cutlery as shown (handles of spoons
facing inwards).
Beware of sharp/pointed items. Risk of
injury!
UPPER RACK
- depending on model:
The two handles
C
must be level.
Washing without the upper rack/cutlery rack
If the appliance is equipped with the adjustable retainers shown in the figure, the upper
rack/cutlery rack can be removed in order to accommodate large items. Open the two
retainers
D
and slide the upper rack/cutlery rack out.
When the upper rack/cutlery rack is in place, the retainers must
always be closed.
LOWER RACK
- depending on model:
Arrange crockery so that water does not collect in cavities, ensuring that the spray arms turn freely.
Only use dishwasher-proof crockery and dishes. Do not use the dishwasher for washing wooden items, aluminium, tin, silver
cutlery or decorated crockery (unglazed).
RINSE
The dishwasher door must be closed and the water tap open.
To load crockery, open the door with caution:
Beware of hot steam!
Close the door again. The programme resumes the cycle from where it was
interrupted.
The wash cycle can be interrupted at any time by pressing
RESET.
PROGRAMME END
Exercise caution when opening the door: beware of
hot steam
.
Press the
OFF
button only after the START button indicator has gone off. All the indicator lamps switch off. Unload the appliance, starting from the lower
rack in order to avoid any residual drips of water falling onto crockery below.
For even better drying results, leave the dishwasher door open a little before unloading in order to allow the steam to
dissipate, helping the dishes to dry. The underside of the kitchen worktop must be protected (see instructions in “Maintenance
and Installation”).
Position 2Position 1
Cutlery holder
A
May be removed individually, depending on upper
rack load.
A
Adjustable glass holder
B
Depending on the position, for small or long-
stemmed glasses.
Rack height adjustment
C
The upper rack height can be changed even when loaded,
Lower adjustment:pull out the two side handles
C
and
lower the rack.
Upper adjustment:pull the two handles
C
up until the rack
clicks into place (standard position).
D
Retainer
closed
Retainer
open
BB
D
C
D
Plate holders
E
Partially folding for maximum rack loading flexibility.
Zone
F
Intensive wash with
Power Clean
.
F
E
Changing the programme in progress/ Resetting
- Press the START button for 2 sec. until the START indicator
lamp switches off.
- (Water drains for up to 60 seconds).
- The appliance is now ready to be restarted.
Built-in models
- Press the START/RESET button (for 2 seconds).
-Close the door.
- (Water drains for up to 60 seconds).
- The appliance is now ready to be restarted.