Instruction for Use
65
QUICK OPERATION GUIDE
For detailed operating method read the corresponding content on the instruction manual.
Switch on the
appliance
Open the door,press the On/Off button to switch on the appliance.
Switch off the
appliance
When the working cycle has finished, the buzzer of the dishwasher will sound 3 times, then stop. Turn
off the appliance using the On/Off Button.
Turn off the water tap,
unload the baskets
Warning: wait a few minutes (about 15 minutes) before unloading the dishwasher to avoid handling the
dishes and utensils while they are still hot and more susceptible to break.
They will also dry better.Unload the appliance, starting from the lower basket.
Fill the detergent
dispenser
Compartment A:
With each wash cycle.
Compartment B:
For programmes with pre-wash only.(Follow the user instructions!)
Check the rinse aid
level
Mechanical indicator C.
Electric indicator on control panel (if provided).
Check the
regeneration
salt level
On models with water softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel (for some models), you can
estimate when to fill the salt into the softener by the number of cycles the dishwasher
has run.
Load the baskets
Scrape off any large amount of leftover food. Soften remnants of burnt food in pans,
then load the baskets. Refer to the dishwasher loading instructions
Select a program
Press the Programme Button until the selected programme lights up.
(See the section entitled “Operation instruction”)
Running the
dishwasher
Turn on the water tap, close the door. The machine will start working after about 10 seconds.
Changing the program
1. A running cycle can only be modified if it has been running for a short time. Otherwise the detergent
may have already been released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. Press the Program Button for more than 3 seconds to cancel the running programme.
3. Select a new programme.
4. Restart the dishwasher.
Add forgotten dishes
in the dishwasher.
1. Open the door a little to stop the dishwasher.
2. After the spray arms stop working, you can open the door completely.
3. Add the forgotten dishes.
4. Close the door, the dishwasher will start running again after 10 seconds.
If the appliance is
switched off during a
wash cycle.
If the appliance is switched off during a wash cycle, when switched on again, please re-select the
washing cycle and operate the dishwasher according to the original ”Power-on state”).
WARNING!
Open the door
carefully.
Hot steam may
escape when the
door is opened