Manual

CYCLES LOAD TYPES FABRIC SELECT DESCRIPTIONS APPROXIMATE
Agitation/Spin AGITATION
Speeds TIMES
PRETREAT** Any garment type May be used with Features bgef agitations in a 20-
AUTO SOAK** Fcllowinstructionson any FABRIC SELECT minute soak before automatically
the garment care tag option advancing to PRE-WASH.
PRE=WASH "_ Features 6 minutes of agitation
followed by Drain and Spin.
**Use the amount of detergent or presoak additive recommended by the manufacture_ After the cycle ends, you may add detergent
and start a new wash cycle.
The timed bleach dispenser autometica_ly dispenses liquid
chlorine bleach to the wash load a few minutes after agitation
begins in order to give the detergent time to achieve the best soil
and stain removal
NOTE; Do not use this dispenser to add powdered chlorine or
color-safe bleach to your wash load. The dispenser is for liquid
chferme bleach only. Color safe or powdered bleach should be
added with your detergent.
You may turn the Extra Rinse Control knob to ON to get a second
rinse at the end of any of your regufer cycles.
On models without an Extra Rinse Control knob you may choose
a second rinse by pushing the cycle contro_ knob in and rotating it
to any of the "Rinse" settings.
The End of Cycle Signal is helpful when you are washing Items
that should be removed from the washer as soon as the cycle
ends.
Using the Extra Rinse Control and End of Cycle Signal Control
• Set the selector to OFF/OFF if you do not desire an Extra
Rinse or an End of Cycle Signal.
• Set the selector to ON/OFF for an Extra Rinse only.
• Set the selector to OFF/ON for an End of Cycle Signal only.
• Set the selector to ON/ON for an Extra Rinse and an End of
Cycle Signal.
You should select a Wash/Rinse temperature based on the type of
fabric and soils being washed. For best results, use the warmest
wash water safe for fabric. Follow garment label instructions.
ACCUWASH TM Control
Some models use the ACCUWASH TM automatic temperature
control The ACCUWASN f_ feature maintains a uniform water
temperature by regufeting incoming hot and cold water. This helps
eliminete undissolved detergent and ensures consistent cleaning.
The cold wash is regulated at approximately 70°F (21°C). The
warm wash is maintained at approximately 95°E (35°(3).To reduce
wnnkting, the warm dnse is regufeted to be cooler than the warm
wash.
NOTE; Make sure that both hot and cold water faucets are turned
on or the ACCUWASH TM feature will not work properly.
Adjust water level to load size. Dfethes should move freely. To
change to a higher water _evel after agitation starts_ you may turn
knob to desired setting.
On models with a vanadfe Load Size or Water Level control you
should turn the knob to RES_ then to desired setting.