Manual

ELECTRONICOVENCONTROLS
Style 1 - Electronic Oven Controls (on some models)
A B C D E
/
The START or START/ENTER pad begins any oven function. If not
pressed within 5 seconds after pressing a function pad, the
"START?" indicator light will flash as a reminder. On some
models, "START?" will appear on the display.
If not pressed within 5 minutes after pressing a function pad, the
oven display will return to the time of day mode and the
programmed function will be canceled.
G H f J K L M
A. Display
B. Timer
C. Clock
D. Auto clean
E. Oven light pad
(on some models)
E Sequence programming
(on some models)
G. Oven settings
H. Warming drawer
(on some models)
I. Temperature
J. Timed cooking
(on some models)
K. Hour/minute
(on some models)
L. Start/control lock
M. Cancel
Style 2 - Electronic Oven Controls (on some models)
B CDE
Bake Broil Clean
Delay Door Conlrols
Locked Locked
On
K J f H
fiMP E_ SE_*C_CLEANtNG OVEN
G
A. Oven display G. Temperature/time
B. Clock H. Cook time
C. Timer/cancel I. Start time
D. Start/enter (control lock) J. Custom broil
E. Auto clean K. Bake
F Off/cancel
When power is first supplied to the appliance, "PF" or a flashing
time will appear on the display. Press CANCEL or OFF/CANCEL
to clear "PF" or flashing time from the display.
If "PF" or flashing time appears, a power failure has occurred.
Press CANCEL or OFF/CANCEL and reset the clock if needed.
When the oven is not in use, the display shows the time of day.
When performing a timed cook function, the display will show
either hours and minutes, or minutes and seconds.
The CANCEL or OFF/CANCEL pad stops any function except the
Clock, Timer and Control Lock.
On some models, this is a 12-hour clock that shows a.m. and
p.m.
To Set:
Before setting, make sure the oven and Timer are off.
1. Press CLOCK.
2. Depending on your model, press the HR or MIN or TEMP/
TIME "up" or "down" arrow pads to set the time of day,
including a.m. or p.m.
3. Press CLOCK or START.
Tones are audible signals, indicating the following:
One tone
• Valid pad press
• Oven is preheated (long tone)
• Function has been entered
• Reminder, repeating each minute after the end-of-cycle tones
Three tones
• Invalid pad press
Four tones
• End of cycle
Reminder Tones: Reminder tones may be turned off. On some
models, press and hold STOP TIME for 5 seconds. "rEP OFF" or
"off" will appear in the display. Repeat to turn reminder tones
back on, and "rEP on" or "on" will appear in the display.
All Tones: All of the above tones are preset on, all except the
end-of-cycle tones can be turned off.
To Turn Off/On (on some models): Press and hold START TIME
for 5 seconds. A tone will sound, and "Snd OFF" will appear on
the display. Repeat to turn tones on, and "Snd on" will appear on
the display.
On some models, only the loudness of the tones can be adjusted.
On other models, the tones cannot be adjusted or turned off.