Installation guide

ManualsBrandsWhirlpool ManualsOvenGR563LXSS2

1. Checkthatallpartsarenowinstalled.Ifthereisanextrapart,

gobackthroughthestepstoseewhichstepwasskipped.

2. Checkthatyouhaveallofyourtools.

3. Disposeof/recycleallpackagingmaterials.

4. Checkthattherangeislevel.See"LevelRange."

5. Useamildsolutionofliquidhouseholdcleanerandwarm

watertoremovewaxyresiduecausedbyprotectiveshipping

material.Drythoroughlywithasoftcloth.Formore

information,readthe"RangeCare"sectionoftheUseand

CareGuide.

6. Read"RangeUse"intherangeUseandCareGuide.

7. Plugpowercordintoappropriateoutlet.Turnpoweron.

8. Turnonsurfaceburnersandoven.SeetheUseandCare

Guideforspecificinstructiononrangeoperation.

If range does not operate, check the following:

• Household fuse is intact and tight; or circuit breaker has not

tripped.

• Range is plugged into an outlet.

• Electrical supply is connected.

• See "Troubleshooting" in the Use and Care Guide.

When the range has been on for 5 minutes, check for heat. If

range is cold, turn off the range and contact a qualified

technician.

Mo 7 n(s [{}c,sncs®

..... _}S......... _sS_'

Tip Over Hazard

A child or adult can tip the range and be killed.

Connect anti-tip bracket to rear range foot.

Reconnect the anti-tip bracket, if the range is moved.

Failure to follow these instructions can result in death

or serious burns to children and adults.

When moving range, slide range onto cardboard or hardboard to

avoid damaging the floor covering.

If removing the range is necessary for cleaning or maintenance:

For power supply cord-connected ranges:

1. Unplug the power supply cord.

2. Slide range forward to complete cleaning or maintenance.

3. Check that anti-tip bracket is installed:

• Look for the anti-tip bracket securely attached to floor.

• Slide range back so rear range foot is under anti-tip

bracket.

4. Check that range is level.

For direct-wired ranges:

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

1. Disconnect power.

2. Disconnect wiring.

3. Slide range forward to complete cleaning or maintenance.

4. Check that anti-tip bracket is installed:

• Look for the anti-tip bracket securely attached to floor.

• Slide range back so rear range foot is under anti-tip

bracket.

Check that range is level.