Installation guide

INSTALLATIONINSTRUCTIONS
4. Assemble hold-down screws to hold-down bracket. See
illustration below.
....
A"
O _,,_ _,_,,_
Write down the model and serial numbers before installing the
cooktop. Both numbers are located on the center underside of the
burner box.
Unpack the parts supplied with your cooktop. The parts shipped
with the cooktop depend on the model ordered. See "Tools and
Parts" section for a complete list parts supplied with the cooktop.
Decide on the final location for the cooktop. Locate existing wiring
to prevent drilling into or severing wiring during installation.
The pressure regulator and flexible stainless steel gas supply line
connector can be assembled to the cooktop now or after the
cooktop is installed in the cutout. See "Make Gas Connection"
section.
1. Using two or more people, place the cooktop upside down on
a protective surface.
2. Remove foam strip from hardware package. Remove backing
from foam strip. Apply foam strip adhesive-side down around
bottom of cooktop, 1A6"(1.6 mm) from the edge of the
stainless steel frame sides and back.
NOTE: The foam strip protects the underside of the cooktop
frame from debris and helps the cooktop sit flat on uneven
counters.
B
/
i!
A. Countertop D. Hold-down bracket
B. Wood block E. Burner box
C. Hold-down screw
Center the cooktop in the opening and using a wood block
between the screw and the countertop, tighten the screws
moderately to secure cooktop.
IMPORTANT: Do not tighten screws directly against the
countertop.
To Assemble Pressure Regulator:
1. Stand the cooktop on its side or back.
2. Connect the flexible stainless steel connector to the pressure
regulator using a 1/2"male pipe thread adapter.
A combination of pipe fittings must be used to connect the
cooktop to the existing gas line. Shown following is a typical
connection. Your connection may be different, according to
the supply line type, size and location.
3. Install the pressure regulator with the arrow pointing up
toward the bottom of the burner box and in a position where
you can reach the regulator.
A. Burner box
B. Foam strip
C. Stainless steel frame
D. _6" (!.6 ram)
1. Remove the 2 screws located in each side of the cooktop
burner box.
2. Attach the 2 hold-down brackets to the burner box.
3. Install the cooktop into the countertop cutout by tilting one
end of the cooktop into the cutout, then lowering the other
end into the cutout.
%D
A. Gas pressure regulator
B. Up arrow - Regulator must be installed with
arrow pointing up at cooktop bottom.
C. Adapter - Must have ½" male pipe thread
D. UL listed or CSA approved flexible stainless
steel gas supply line