Installation guide

ManualsBrandsWhirlpool ManualsCooktopOfficial Whirlpool gas counter unit

INSTALLATION INSTRUCTIONS

30"(76.2CM)AND36"(91.4CM)GASBUILT.INCOOKTOP

INSTRUCTIONSD'INSTAILATIONDELATABLEDECUISSONA

GAZENCASTREEDE30"(76,2CM)ET 3g' (91,4CM)

Table of Contents / Table des mati_res

COOKTOP SAFETY .......................................... 1

INSTALLATION REQUIREMENTS .................. 2

Tools and Parts .............................................. 2

Location Requirements ................................. 2

Electrical Requirements ................................. 4

Gas Supply Requirements ............................ 4

INSTALLATION INSTRUCTIONS .................... 6

Prepare Cooktop for Installation ................... 6

Install Cooktop .............................................. 6

Make Gas Connection ................................... 6

Complete Installation ..................................... 7

WIRING DIAGRAMS ......................................... 8

SI_CURITI_ DE LA TABLE DE CUISSON ......... 9

EXIGENCES D'INSTALLATION ..................... 10

Outillage et pieces ....................................... 10

Exigences d'emplacement .......................... 10

Specifications 61ectriques ............................ 11

Sp6cifications de I'alimentation en gaz ....... 12

INSTRUCTIONS D'INSTALLATION ............... 13

Pr6paration de la table de cuisson

pour I'installation .......................................... 13

Installation de la table de cuisson ............... 13

Raccordement au gaz .................................. 14

Achever I'installation .................................... 15

SCHI_MAS DE CABLAGE .............................. 15

COOKTOPSAFETY

Your safety and the safety of others are very important.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety

messages.

This is the safety alert symbol.

This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."

These words mean:

You can be killed or seriously injured if you don't immediately

follow instructions.

You can be killed or seriously injured if you don't follow

instructions.

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can

happen if the instructions are not followed.

iMPORTANT:

Save for local electrical inspector's use.

Installer: Leave installation instructions with the homeowner=

Homeowner: Keep installation instructions for future reference=

iMPORTANT :

_, conserver pour consultation par Hnspecteur local des installations 61ectriques.

InstaHateur : Remettre les instructions d'installation au propri6taire.

Propri6taire : Conserver les instructions d'installation pour ref6rence ulterieare=

9761893

Summary of content (16 pages)

PAGE 1
INSTALLATION INSTRUCTIONS 30"(76.2CM)AND36"(91.4CM) GASBUILT.IN COOKTOP INSTRUCTIONSD'INSTAILATION DELATABLEDECUISSONA p GAZENCASTREEDE 30"(76,2CM)ET 3g' (91,4CM) Table of Contents / Table des mati_res COOKTOP SAFETY .......................................... 1 SI_CURITI_ DE LA TABLE DE CUISSON ......... 9 INSTALLATION REQUIREMENTS .................. 2 Tools and Parts .............................................. 2 EXIGENCES D'INSTALLATION ..................... 10 Outillage et pieces ...............
PAGE 2
I WARNING: For your safety, the information in this manual must be followed to minimize the risk of fire or explosion, or to prevent property damage, personal injury, or death. - Do not store or use gasoline or other flammable or any other appliance. - WHAT TO DO IF YOU SMELL vapors and liquids in the vicinity of this GAS: • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Clear the room, building, or area of all occupants.
PAGE 3
• Thegasandelectric supplyshould belocated asshownin "GasandElectric Connection Locations" section sothatthey areaccessible without requiring removal ofthecooktop. IMPORTANT: Toavoiddamage, checkwithyourbuilder or cabinet supplier tomakesurethatthematerials usedwillnot discolor, delaminate orsustain otherdamage.
PAGE 4
Electrical ShockHazard Plugintoa grounded 3 prongoutlet. Donotremovegroundprong. Donotuseanadapter. Donotuseanextension cord. Failure to follow these instructions fire, or electrical shock. can result in death, Explosion Use a new OSA International This cooktop is will not operate polarized. This cooktop is will not operate circuit. gas supply line. Securely tighten all gas connections. tf connected to LP, have a quaified person make sure gas pressure does not exceed 14" (36 cm) water column.
PAGE 5
Gas Supply Line Gas Pressure Regulator Provide a gas supply line of 3A"(1.9 cm) rigid pipe to the cooktop location. A smaller size pipe on longer runs may result in insufficient gas supply. Pipe-joint compounds that resist the action of LP gas must be used. Do not use TEFLON ®ttape. With LP gas, piping or tubing size can be r/2" minimum. Usually, LP gas suppliers determine the size and materials used in the system.
PAGE 6
INSTALLATIONINSTRUCTIONS 4. Assemble hold-down illustration below. A" screws to hold-down .... O _,,_ A. Countertop B. Wood block C. Hold-down screw Write down the model and serial numbers before installing the cooktop. Both numbers are located on the center underside of the burner box. bracket. See _,_,,_ D. Hold-down bracket E. Burner box Center the cooktop in the opening and using a wood block between the screw and the countertop, tighten the screws moderately to secure cooktop.
PAGE 7
IMPORTANT: All connections must be wrench-tightened. Do not make connections to the gas regulator too tight. Making the connections too tight may crack the regulator and cause a gas leak. Do not allow the regulator to turn on the pipe when tightening fittings. Remove surface burner heads, caps and grates from parts package. Insert tab in burner head into notch in burner base, Place burner cap on burner head.
PAGE 8
WIRINGDIAGRAMS CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. The power cord on this appliance is equipped with a 3 prong grounding plug that mates with standard 3 prong grounding-type plug. Verify proper operation after servicing. On 30" (76.
PAGE 9
SECURITEDELATABLEDE CUISSON Votre s_curit_ et celle des autres est tr_s importante. Nous donnons de nombreux messages de securite importants dans ce manuel et sur votre appareil menager. Assurez-vous toujours lire tousles messages de securite et de vous y conformer. de Ce symbole d'alerte de securite vous signale les dangers potentiels de deces et de blessures graves h vous et h d'autres. Voici le symbole d'alerte de securite.
PAGE 10
EKIGENCESD'INSTALLATION • Rassembler les outils et pieces necessaires avant de commencer I'installation.
PAGE 11
Emplacements d'_lectricit_ des raccordements des sources de gaz et A I C ..................... B REMARQUE : Apr_s le decoupage de I'ouverture dans le plan de travail, clans certaines configurations d'installation il sera necessaire d'entailler les parois laterales du placard inferieur pour le passage de la bofte des breleurs. Pour eviter cette modification, utiliser un placard inferieur dont la largeur des parois laterales est superieure & celle de I'ouverture decoupee.
PAGE 12
• L'appareil dolt _tre alimente par un circuit de 120 V, CA seulement, 60 Hz, 15 amperes, protege par fusible. On recommande egalement d'utiliser un fusible ou un disjoncteur temporise. I1est recommande de raccorder la table de cuisson sur un circuit distinct exclusif a cet appareil. • Les systemes d'allumage electronique fonctionnent avec des {imites de tension etendues, mais une liaison a la terre correcte et une polarite appropriee sent n_cessaires.
PAGE 13
D_tendeur Le d&tendeur fourni avec cette table de cuisson dolt _tre utilis6. La pression d'alimentation du d6tendeur dolt _tre comme suit pour un fonctionnement correct : Gaz naturel : Test de pressurisation de la canalisation de gaz Pressurisation a une pression sup_rieure a 1/2Ib/po 2 (14" - colonne d'eau) Pour tout test de pressurisation du systeme A une pression superieure A 1/2Ib/po 2(3,5 kPa), on dolt deconnecter la table de cuisson et son robinet d'arr_t manuel de la canalisation A pressuriser.
PAGE 14
5= Centrer la table de cuisson dans I'ouverture et, en utilisant une cale en bois entre la vis et le plan de travail, serrer les vis mod@ement pour fixer la table de cuisson. IMPORTANT : Ne pas serrer les vis directement contre le plan de travail. 3. Utiliser une cle mixte de 1sAd'et une pince multiprise pour fixer le raccord flexible sur les raccords d'adaptation. Veiller a ne pas ddormer/ecraser le raccord flexible. Assemblage du d_tendeur : 1.
PAGE 15
Systbme d'allumage 61ectronique Contr61e du fonctionnement des brQleurs de surface 1. Enfoncer et tourner les boutons de commande de breleur de surface a la position "HI" (eleve). 2. 3. 4. Si le brQleur ne s'allume pas correctement : • Ramener le bouton de commande du breleur de surface & la position "OFF". Le gaz dolt s'enfiammer sur le breleur de surface en moins de 4 secondes.
PAGE 16
Sur les modbles de 36" (91,4 cm) _,o u R{; E D'AU_4ENTATION N T L1 ' I_BL_g SCHEMA DE C_,BLAGE GLS3665 TABLE DE CUISSON 9761893 © 2005 Whirlpool Corporation. All rights reserved. Tous droits r_serves. 5/05 Printed in U.S.A. Imprime aux E.-U.