Manual

COOI OP CONTROLS-TOUCH.ACTIVATEDMODELS
Fire Hazard
Turn off all controls when done cooking.
Failure to do so can result in death or fire.
The electronic touch controls offer a variety of heat settings for
optimal cooking results. When you are melting foods such as
chocolate or butter, or when proofing bread, the surface cooking
area can be set to WARM HI for minimal element operation.
For maximum element operation, all cooktop touch controls can
be set to HI when bringing liquids to a fast and rapid boil. Touch
the "minus" (-) keypad to immediately reach the HI setting.
Use the following chart as a guide when setting heat levels.
i
SETTING RECOMMENDED USE
HI Start food cooking.
Bring liquid to a boil.
Medium High Hold a rapid boil.
Between MED - HI
Quickly brown or sear food.
MED Maintain a slow boil.
Medium Fry or saute foods.
Medium Low Cook soups, sauces and
Between MED - LO gravies.
Stew or steam food.
SIMMER HI Provide lowest simmer/heat
SIMMER LO settings.
WARM HI Keep larger amounts of food
warm.
Melt chocolate or butter.
WARM LO Keep smaller amounts of food
warm.
Dual Size Elements Home canning.
Large-diameter cookware.
Large quantities of food.
To Use:
1. Touch ON/OFF.
2. Touch the "+" or "-" keypads to increase or decrease power.
3. To choose a power level between HI and WARM LO, touch
and hold either the "+" or "-" keypad until the desired level
has been reached.
4. When finished cooking, touch ON/OFF to turn surface
cooking area(s) off individually, or touch ALL OFF to turn all
elements off at the same time.
I REMEMBER: When cooktop is in use, the entire cooktop
I
area may become hot.
I
Hot Surface Indicator Lights
The Hot Surface Indicator Lights are located next to each of the
cooktop touch controls. The Hot Surface Indicator Lights will
glow as long as any surface cooking area is too hot to touch,
even after the surface cooking area(s) is turned off.
A. Hot surface indicator light
If the cooktop is on when a power failure occurs, the Hot Surface
Indicator Lights will remain on after the power is restored to the
cooktop. They will remain on until the cooktop has cooled
completely.