Use and care guide

4
Remove the nozzle using a 7
mm socket wrench.
Screw the new injector in fully
(diameter in hundredths of
millimetre stamped on the
injector), taking care not to cross
the thread.
Replace the burner reversing the
operations in step 2 above.
Replace the cover plate.
Adjusting the minimum ame.
Before installing the oven,
remember to ax the gas
calibration plate supplied with
the injectors in such a way that it
covers the existing information
relating to gas calibration.
For the Grill, upper side
Remove the burner screw
located at top front of the oven
cavity.
Remove the burner together
with its heat elements.
Remove the injector using the 7
mm socket wrench.
Fully tighten the new injector
which must be of the diameter
indicated in the table in the
chart table.
Put back the burner and secure
it with the screw.
Installation and repairs must be
carried out by a qualied
technician, in compliance with
the manufacturer’s instructions
and local safety regulations. Do
not repair or replace any part of
the appliance unless specically
stated in the user manual.
Children should not perform
installation operations. Keep
children away during
installation. Keep the packaging
materials (plastic bags,
polystyrene parts, etc.) out of
reach of children, during and
after the installation.
After unpacking the appliance,
make sure that it has not been
damaged during transport. In
the event of problems, contact
the dealer or your nearest After-
sales Service.
The appliance must be
disconnected from the power
supply before any installation
operation.
During installation, make sure
the appliance does not damage
the power cable.
Only activate the appliance
when the installation has been
completed.
After installation, the bottom of
the appliance must no longer be
accessible.
Carry out all cabinet cutting
works before tting the
appliance in the furniture and
carefully remove all wood chips
and sawdust.
Do not obstruct the minimum
gap between the worktop and
the upper edge of the oven.
Only remove the oven from its
polystyrene foam base at the
time of installation.
Do not install the appliance
behind a decorative door - Risk
of re.
ELECTRICAL WARNINGS
For installation to comply with
current safety regulations, an
omnipolar switch with minimum
contact gap of 3 mm is required
and the appliance must be
earthed.
If the power cable is damaged,
replace with an identical one.
The power cable must only be
replaced by a qualied
technician in compliance with
the manufacturer instruction
and current safety regulations.
Contact an authorized service
center.
It must be possible to
disconnect the appliance from
the power supply by unplugging
it if plug is accessible, or by
means of an accessible multi-
pole switch installed upstream
of the socket in conformity with
national electrical safety
standards.
The rating plate is on the front
edge of the oven (visible when
the door is open).
In case of replacement of power
cable, contact an authorized
service center.
IMPORTANT: The data rilevant
to the voltage an power
absortions are indicated on the
rating plate
If the tted plug is not suitable
for your socket outlet, contact a
qualied technician.