Instruction for Use

12
Before using the dishwasher/Connections
1. Removing the packaging
and controls:
After unpacking, make sure that
the dishwasher is undamaged
and that the door closes
correctly.
If in doubt, contact a qualified
technician or your local retailer.
• Keep the packaging materials
(plastic bags, polystyrene parts,
etc.) out of reach of children, as
they are potentially dangerous.
• This dishwasher has been
factory tested to ensure it
functions correctly.
Such testing may leave slight
water marks that will disappear
with the first wash.
2. Water and electrical
connections:
All water and electrical
connections must be carried
out by a qualified technician in
compliance with the
manufacturer's instructions
(refer to the enclosed
installation booklet) and
current local safety regulations.
The appliance must only be
used in the household for the
prescribed uses.
Do not use the dishwasher if it
has been damaged in transit.
Consult your local retailer or
our After-Sales Service.
(Refer to the separate
installation instructions
booklet)
3. Water inlet and drain:
• Observe any special regulations
issued by your local Water
Board.
Water supply pressure:
0.3-10bar.
• Make sure the inlet and drain
hoses are kink-free and are not
crushed.
• If the hose length is not
sufficient, please contact your
local dealer or our After-Sales
Service.
• The inlet hose must be securely
clamped to the water tap to
prevent leaks.
• The inlet water temperature
varies according to the model
installed. Inlet hose marked
“25°C Max”:
maximum temperature 25°C.
All other models: maximum
temperature 60°C.
• When installing the appliance,
make sure the drain water
discharges correctly (if
necessary, remove the wire
gauze from the sink siphon).
• Fix the drain hose to the spigot
with a clamp to prevent it from
coming off during operation.
For appliances with water-stop
system only: if the water
connections are made correctly,
the water-stop system
safeguards your home against
damage caused by flooding.
4. Electrical connection:
• Closely adhere to local
Electricity Board regulations.
• Voltage information is shown on
the rating plate mounted inside
the door on the right hand side.
• The appliance must be earthed as
prescribed by law.
• Do not use extension leads or
multiple adapters.
• Before carrying out
maintenance, disconnect the
mains plug.
• If necessary, the power cable
may be replaced with one the
same obtained from our After-
Sales Service. The power cable
must only be replaced by a
qualified technician.
• For Austria:
if the apparatus is
series connected to a fault
current switch, this must be
sensitive to the pulsating
current.
4gb94600.fm Page 12 Wednesday, September 11, 2002 6:07 PM