Setup and user guide

PROGRAMMES
For choosing the appropriate programme for your kind of
laundry, always respect the instructions on the care labels
of the laundry. The value given in the tub symbol is the
maximum temperature possible for washing the garment.
Mixed
For washing lightly to normally soiled resilient garments in cotton,
linen, synthetic bres and mixed bres.
White
For washing normally to heavily soiled towels, underwear, table and
bed linen, etc in resilient cotton and linen. Only when the temperature
is selected at 90°C the cycle is provided with a prewash phase before
main washing phase. In this case it is recommended to add detergent
both, in the prewash and main wash section.
Cotton
Normally to heavily soiled and robust cottons .
Cotton
For washing normally soiled cotton garments. At 40°c and 60°C, this
is the standard cotton programme and the most ecient in terms of
water and energy consumption.
Sport
For washing lightly soiled sports clothing (tracksuits, shorts, etc.).
For best results, we recommend not exceeding the maximum load
indicated in the ‚‘‘PROGRAMME CHART‘‘. We recommend using liquid
detergent , and adding the amount suitable for half-load.
Duvet
Designed for washing eiderdown padded items such as double or
single duvets, cushions and anoraks. It is recommended to load such
padded items in the drum with the edges folded inwards and not to
exceed ¾ of the drum’s volume. For optimal washing, we recommend
using a liquid detergent.
Jeans
Turn garments inside-out before washing and use a liquid detergent.
Spin & Drain
Spins the load then empties the water. For resilient garments. If you
exclude the spin cycle, the machine will drain only
Rinse & Spin
Rinses and then spins. For resilient garments.
Rapid 30’
For washing lightly soiled garments quickly. This cycle lasts only 30
minutes, saving time and energy.
Colours 15°
This cycle helps protect colours by washing in cold water (15°C) and
uses less energy to heat the water while still oering satisfactory wash
results. Suitable for lightly soiled, unstained garments. This cycle oers
wash results comparable to 40°c mixed at just 15°C
Wool
All wool garments can be washed using programme ‚“Wool“ even
those carryng the “hand-wash only “ label. For best results, use special
detergents and do not exceed max kg declaration of laundry.
Delicates
For washing particularly delicate garments. Preferably turn garments
inside out before washing.
Synthetics
For washing soiled garments made from synthetic bres (such as
polyester, polyacrylic, viscose, etc.) or cotton/synthetic blends.
FIRST TIME USE
To remove any manufacturing debris select the “Cotton” programme at
a temperature of 60°C. Pour a small quantity of detergent powder into
the main wash compartment of the detergent dispenser (maximum
1/3 of the quantity the detergent manufacturer recommends for lightly
soiled laundry). Start the programme without adding any laundry.
DAILY USE
Prepare your laundry according to the recommendations in the “HINTS
AND TIPS” section. Load the laundry, close the door, open the water tap
and press the “ON/OFF” button to switch the wasching machine on,
the “Start/Pause” button ashes. Turn the programme selector to the
desired programme and select any option if needed. The temperature
and spin speed displayed via the corresponding LED light can be
altered by pressing the “Temp.” button or the “Spin speed” button. Pull
out the detergent dispenser and add the detergent (and additives/
softener) now. Observe the dosing recommendations on the detergent
pack. Then close the detergent dispenser and press the “Start/Pause”
button. The “Start/Pause” button will light up and the door will
be locked.
PAUSE A RUNNING PROGRAMME
To pause the wash cycle, press the “Start/Pause” ; the indicator
light will ash. To start the wash cycle from the point at which it was
interrupted press the button again.
OPEN THE DOOR, IF REQUIRED
After starting a programme, the “Door locked” indicator lights up to
show that the door can not be opened. As long as a wash programme is
running, the door remains locked. To open the door while a programme
is in progress, press the “Start/Pause” to pause the programme.
Provided the water level and/or temperature is/are not too high, the
“Door locked” indicator light goes o and you can open the door. For
example to add or remove laundry. Press the “Start/Pause” button
again to continue the programme.
PROGRAMME END
The “Door locked” indicator light goes o and “Cycle end”
indicator lights up. To switch o the washing machine after programme
end press the “ON/OFF” button, the lights goes o. If you do
not press “ON/OFF” button, the washing machine will switch o
automatically after about a half of an hour. Close the water tap, open
the door and unload the washing machine. Leave the door ajar to allow
the drum to dry.
OPTIONS
! If the selected option is incompatible with the programme set,
the incompatibility will be signalled by a buzzer (3 beeps) and the
corresponding indicator light will ash.
! If the selected option is incompatible with another previously set
option, only the most recent selection will remain active.
FreshCare+
This option enhances washing performance by generating steam
to inhibit the proliferation of the main bad odour sources inside the
machine. After steam phase, the washing machine will perform gentle
tumbling through slow rotations of the drum. FreshCare+ option starts
after the cycle ends for a maximum duration of 6h and you can interrupt
it at any time by pressing any button on control panel or turning the
knob. Wait around 5 minutes before open the door.
Intensive rinse
By selecting this option, the eciency of the rinse is increased and
optimal detergent removal is guaranteed. It is particularly useful for
sensitive skin.
Easy ironing
By selecting this option, the wash and the spin cycles will be modied
in order to reduce the formation of creases.
Start delay
To set the selected programme to start at a later time, press the button
until the LED for the desired delay is illuminated (9h - 6h - 3h). After the
wash cycle has been started the indicator light corresponding to the
selected delay period will begin to ash. As time passes, the remaining
delay will be displayed and the corresponding indicator light will ash.
The set programme will start once the selected time delay has expired.
To cancel the delayed start, press the button until all LED lights are
switched o.