Instruction for Use

User manual
10
5. Add detergent
Pull out the detergent dispenser and add
detergent (and additives/softener) into the relative
compartments as described in section “DETERGENT
DISPENSER”. Observe the dosing recommendations
on the detergent pack.
Correct dosing of detergent / additives is important, because:
• it optimizes the cleaning result
• it avoids irritating residues of surplus detergent in your
laundry
• it saves money by avoiding waste of surplus detergent
• it protects the washing machine by avoiding
calcication of components
• it respects the environment by avoiding unnecessary
environmental burden.
6. Delaying the start of a programme
• To set a programme to start at a later time, see the
section “OPTIONS/ START DELAY”
7. Start programme
• Press the “Start/Pause” . The relative indicator lamp
illuminates, the door locks and the “Door locked”
indicator lights up.
• To avoid overow, do not open the detergent
dispenser during a running programme anymore.
• The remaining programme duration can vary. Factors
like unbalance in the wash load, or foam formation, can
have an eect on the programme duration.
8. Change the settings of a running programme, if
needed
You can still change the settings while a programme is
running. The changes will be applied, provided the respective
programme phase has not nished yet.
To change the settings of a running programme:
• Press “Start/Pause” to put the running programme
on pause.
• Change your settings.
• Press “Start/Pause” again to continue the
programme.
If you have changed the programme, do not add detergent
for the new programme.
To prevent that a running programme is changed by accident
(for instance by children), use the “Key lock” (see section
“FUNCTIONS”).
Pause a running programme and open the door, if
needed
• Press “Start/Pause” to pause a running programme.
• Provided water level or temperature is not too high,
the “Door locked” indicator light turns o. You can
open the door, for example to add more laundry, or to
remove laundry which was loaded by mistake.
• Press “Start/Pause” to proceed with the
programme.
9. Cancelling a running programme, if needed
• Press and hold the “ON/OFF“ button until the
washing machine stops.
• If the water level and temperature are low enough, the
door unlocks and may be opened.
• The door remains locked if there is water in the drum.
To unlock the door, switch the washing machine on,
select the "Spin & Drain" programme and turn the spin
option o by setting the spin speed to “0“.
• The water is emptied and the door unlocks at the end
of the programme.
10. Switch o the washing machine after programme End
• At the end of the cycle, the message "END" is shown on
the display.
• The door can only be opened when the symbol “Door
locked” light turns o.
• Check that the “Door locked” indicator is o, then
open the door and take out the laundry.
• Press “ON/OFF” to switch the washing machine o.
To save energy, if the washing machine is not switched
o manually with the button, it turns o automatically
approximately 30 minutes after the end of the programme.
Leave the door ajar to let the interior of the washing
machine to dry.