Instruction for Use

12
GB
Special wash cycles
and Options
* Only available in selected models.
Delay Timer option
It is possible to delay the start time of the cycle by
1 to 24 hours:
1. Select the desired wash cycle and any other options
required, press the DELAY TIMER button. The relevant symbol
starts flashing. Use the buttons + and - to select when the
wash cycle will start (h01, h02 etc.)
2. Confirm with the START/PAUSE button. The symbol stops
flashing and the countdown begins.
3. Once this time has elapsed, the DELAY TIMER symbol
switches off and the wash cycle begins.
To deselect the DELAY TIMER option, press the DELAY TIMER
button until the text OFF appears.
The Delayed Start function cannot be set once a wash
cycle has been started.
Wash options
The OPTIONS may only be set, changed or reset after the
wash cycle has been selected and before the Start/Pause
button has been pressed.
Only the options which are compatible with the type of wash
cycle set may be selected. If an option is not compatible
with the selected wash cycle
(see Table of wash cycles) , the
corresponding symbol flashes rapidly 3 times.
If an option is selected which is not compatible with another
(previously selected) option, it will flash 3 times and switch
off, while the most recently selected option will remain active.
To deselect an option which has been set by mistake, press
the corresponding button again.
Multi-functional tablets option (Multi Tabs)
This option optimises washing and drying results.
When using multi-functional tablets, press the
MULTI-FUNCTIONAL TABLETS button; the corresponding
symbol will light up. If the button is pressed again, the option
will be deselected.
The “Multi-functional tablets” option results in a longer
wash cycle.
Quick Time option
This option can be used to reduce the duration of
the main wash cycles while, maintaining the same washing
and drying performance levels. After selecting the wash cy-
cle, press the QUICK TIME button; the illumination of the
corresponding indicator light indicates its selection. Press
it again to deselect it.
Extra Drying option
To improve the dryness level of the crockery, press
the EXTRA DRYING button and the symbol will light up. If it
is pressed again, the option will be deselected.
A higher temperature during the final rinsing and a longer
drying phase improve the dryness level.
The EXTRA DRYING option increases the duration of the
wash cycle.
Zone Wash option
This option makes it possible to carry out the wash
cycle in the selected rack only. Select the wash cycle and
then press the ZONE WASH button: the selected rack lights
up and the wash cycle starts in the selected rack only. Press
the button again to deselect the option.
The option is available with the following wash cycles:
Intensive and Normal.
Select the option and the Intensive cycle to start the
ULTRAINTENSIVE ZONE washing. This wash cycle is ideal
for very soiled mixed loads, e.g. pans and saucepans,
dishes with heavy encrustation or difficult-to-clean crockery
(grater, vegetable mill, dirty cutlery). The spraying pressure is
stronger and the washing temperature higher, thus ensuring
optimum handling of stubborn stains.
Select the option and the Normal cycle to start the SAVING
ZONE washing. This function makes it possible to reduce
energy consumption. Cycle duration might change.
Remember to load the crockery in the selected rack only
Notes:
Optimum performance levels when using the “Daily wash” and
“Express 30’” cycles can be achieved by respecting the specified
number of place settings.
To reduce consumption even further, only run the dishwasher
when it is full.
Note for Test Laboratories: for information on comparative EN
testing conditions, please send an email to the following address:
[e-mail]