Instruction for Use

1. Locate the water filter cartridge cap below the freezer

compartment door. Rotate the cap counterclockwise to a vertical

position and pull the cap and filter cartridge out through the base

grille.

Note: Since there is water in the cartridge, some spilling may

occur.

2. Remove the cartridge cap by sliding it off the end of the old

cartridge. DO NOT DISCARD THE CAP.

3. Take the new cartridge out of its packaging and remove the

protective cover.

4. Slide the cartridge cap onto the new cartridge as shown.

5. With cartridge cap in the vertical position, push the new filter

cartridge into the base grille until it stops. Rotate the cartridge cap

clockwise to a horizontal position.

6. RUN WATER THROUGH THE DISPENSER UNTIL THE

WATER RUNS CLEAR (about 9-14 litres or 6-7 minutes). This will

clean the system and clear air from the lines.

Note: as air is cleared from the system, water may spurt out of

the dispenser.

Ordering replacement filters

To order more water filter cartridges, please contact your after-

sales service.

CHANGING A WATER FILTER CARTRIDGE