Operation Manual

25
SELECTING THE PROGRAMME
(See also the separate programme chart and
consumption data)
For appliances WITH temperature
selector knob
1.
Turn the programme selector knob
clockwise to the desired programme.
2.
Set the temperature knob to the desired
temperature.
For appliances WITHOUT temperature
selector knob
Turn the programme selector knob clockwise to
the programme with the desired temperature.
PRESS THE DESIRED SPECIAL OPTION
BUTTON
(Depending on model, see also the separate
programme chart).
Spin speed reduction button
•
Press this button to reduce the spin speed.
No spin button
•
Press this button to exclude the spin function
from the programme.
Rinse hold/Spin delay button
•
The laundry remains in the last rinse water
without being spun, to avoid heavy creasing.
•
Especially suitable for the “Synthetic” or
“Delicate” programmes, if the laundry is not
to be unloaded immediately after the end of
the programme.
Stopping Rinse hold
Press the Rinse hold button again; the load
will be spun according to the selected
programme.
Lightly soiled/Half load button
•
Reduces water consumption, above all
during the rinse.
•
Especially suitable for lightly soiled or small
loads (reduce the detergent quantity).
Cold wash button
•
The water is used at the water supply
temperature.
Intensive rinse button
•
This function is especially suitable in areas
with extremely soft water, for baby clothes
and to help people with allergies.
•
In the rinsing cycle approx. 10 l more water
are used.
•
This special function is recommended for the
95°C “Cotton” and 60°C “Synthetic”
programmes, since in this way the wash
water is cooled before drainage.
95°C Cotton
•
This function can be selected in the “Cotton”
programme.
•
Suitable for fabrics with this symbol on the
label.
•
Recommended only for heavily soiled
laundry.
PROGRAMME START
1.
Plug in the appliance.
2.
Turn on the water supply tap.
3.
Press the “ON/OFF” button.
DOOR LOCK
The door locks automatically after the
programme start until the end of the programme.
PROGRAMME END
•
The programme sequence indicator is at “Stop”.
1.
Press the “ON/OFF” button.
2.
Cancel the special options by pressing the
appropriate buttons.
3.
Turn the water supply tap(s) off.
4.
Wait for the door to unlock (about 2 minutes).
5.
Open the door and unload the machine.
Note:
Do not fully close the door but leave it ajar
to allow the drum to dry out.
PROGRAMME RESELECTION
1.
Press the “ON/OFF” button.
2.
Select the new programme, temperature and
relative options.
3.
Press the “ON/OFF” button.
SELECTING THE PROGRAMME
AND SPECIAL OPTIONS / PROGRAMME START
A
B
A
B
DOOR LOCK / PROGRAMME END / PROGRAMME RESELECTION