(Apply the label from warranty here) EN User and maintenance manual
IMPORTANT SAFETY INSTRUCTIONS These instruction shall also be available on website: www.whirlpool.eu YOUR SAFETY AND THAT OF OTHERS IS VERY IMPORTANT This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the danger symbol, pertaining to safety, which alerts users to potential risks to themselves and others.
- This appliance is designed solely for use as a domestic appliance for cooking food. No other type of use is permitted (e.g.: heating rooms). The Manufacturer declines any liability for injury to persons or animals or damage to property if these advices and precautions are not respected. - The appliance and its accessible parts become hot during use. - Care should be taken to avoid touching heating elements.
- During and after the pyrolysis cycle, the animals have to be kept away from the area of the appliance location (only for ovens with Pyrolysis function). - Only use the temperature probe recommended for this oven. - Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass since they can scratch the surface, which may result in shattering of the glass. - Ensure that the appliance is switched off before replacing the lamp to avoid the possibility of electric shock.
SAFEGUARDING THE ENVIRONMENT Disposal of packing material The packing material is 100% recyclable and is marked with the recycle symbol ( in full compliance with local authority regulations governing waste disposal. ). The various parts of the packing must therefore be disposed of responsibly and Scrapping the product - This appliance is marked in compliance with European Directive 2012/19/EU, Waste Electrical and Electronic Equipment (WEEE).
Oven interior IMPORTANT: do not use abrasive sponges or metallic scrapers or scourers. Over time, these can ruin enamelled surfaces and the oven door glass. • After every use, allow the oven to cool then clean it preferably while it is still warm in order to remove built-up dirt and stains caused by food residues (e.g. food with a high sugar content). • Use proprietary oven detergents and follow the manufacturer’s instructions to the letter. • Clean the door glass with a suitable liquid detergent.
MAINTENANCE - WARNING Use protective gloves. Ensure the oven is cold before carrying out the following operations. Disconnect the appliance from the power supply. REMOVING THE DOOR To remove the door: 1. Open the door fully. 2. Lift the catches and push them forwards as far as they will go (Fig. 1). 3. Close the door as far as it will go (A), lift it up (B) and turn it (C) until it is released (D) (Fig. 2). To refit the door: 1. 2. 3. 4. Insert the hinges in their seats. Open the door fully.
REPLACING THE OVEN LAMP To replace the rear lamp (if present): 1. Disconnect the oven from the power supply. 2. Unscrew the lamp cover (Fig. 6), replace the lamp (see note for lamp type) and screw the lamp cover back on (Fig. 7). 3. Reconnect the oven to the power supply. Fig. 6 Fig. 7 N.B.: - Only use 25-40W/230V type E-14, T300°C incandescent lamps, or 20-40W/230 V type G9, T300°C halogen lamps.
COMPATIBLE ACCESSORIES (for the accessories supplied with oven refer to the tech fiche) Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 7 Fig. 8 6a 6b Fig. 5 Fig. 6 Fig. 9 Drip-tray (Fig. 1) For collecting fat and bits of food when placed under the wire shelf, or as a plate for cooking meat, chicken and fish, etc., with or without vegetables. Pour a little water into the drip-tray to avoid spatters of fat and smoke. Baking tray (Fig. 2) For baking biscuits, cakes and pizzas. Wire shelf (Fig.
CONTROL PANEL DESCRIPTION N.B.: The knobs on your oven are retractable, push them in the middle and they pop up. N.B.: Your product may appear slightly different from the drawing. 1. Function selector knob 2. Thermostat knob 3. Red thermostat led 4. Hob control knobs 5. Electronic programmer SWITCHING ON THE OVEN Turn the selector knob to the required function. The oven light switches on. Turn the thermostat knob clockwise to the required temperature.
Setting cooking time After selecting the cooking mode and temperature using the knobs, press the middle button: the display shows 0.00 and the bell symbol flashes. Press the middle button again: on the display and 0.00 appear in sequence and AUTO flashes. Set cooking time using the buttons + and - (the maximum programmable value is 10 hours). After a few seconds the display shows the time of day and AUTO remains lit, confirming the setting.
COOKING TABLE Recipe Preheating Shelf (from bottom) Temp.
Recipe Function Preheating Shelf (from bottom) Temp.
RECOMMENDED USE AND TIPS How to read the cooking table The table indicates the best function to use for any given food, to be cooked on one or more shelves at the same time. Cooking times start from the moment food is placed in the oven, excluding pre-heating (where required). Cooking temperatures and times are purely for guidance and will depend on the amount of food and type of accessory used.
400010833623 GB Whirlpool is a registered trademark of Whirlpool, USA 09/2015
