Ice maker use & care guide EC510

Using Your Ice Maker
Continued
Light
switch
3. Carefully slide the panel out.
4. Choose the color you want to show and
carefully slide the panel back into the lower
access panel.
NOTE: Be careful not to scratch the panel as it
is inserted.
5. Replace the top trim and screws. Replace the
lower access panel assembly and screws.
NOTE: You can make a decorative wood front
to match existing cabinets. The panel should
be l/4” (6 mm) thick and 17” x 11 ‘5/~6”
(433 mm x 303 mm). Remove the color panel
and spacers to allow for wood thickness.
Changing the light bulb
1
Before removing the light bulb, either
unplug the ice maker or disconnect the
. . Elecrl She; Hazard
electnclty leadlng to the Ice maker at the
main power supply. Shock and injury can
occur if electricity remains connected.
The ice maker has a light bulb in the top of the
storage bin. To replace it, open the bin door and
follow these instructions:
1. Disconnect ice maker from power supply.
2. Remove the two thumb screws and slide the
ice cutter grid forward, out of the two slots near
the water pan. Set the ice cutter grid on the bin
door.
3. Press the front of the light shield in while pulling
down to remove it from the light bracket.