Instruction for Use

ENGLISH 14
Ifafaultoccurs,beforecontactingtheAfter-salesService,makethefollowing
checkstotryandremedytheproblem.
Mostfaultscanberemediedbytakingthefollowingcoursesofaction,quickly
restoringnormalapplianceoperation.
Theappliance... Possiblecauses... Solutions...
...isnotworking/willnotstart
- The appliance must be
switched on.
- Check the household circuit fuse
if there is no power supply.
- The dishwasher door
doesn’t close
- Check if the dishwasher’s door
is closed.
- Delayed start option is
ON.
- Check whether the “Delayed
Start” option (if available) has
been selected. If it has, the
appliance will only start once
the set time has elapsed. If
necessary, set the delayed start
to “0” (RESET the appliance).
...theCANCEL/Offindicator
lampblinks6times
- Water tap closed. - The water tap must be open.
- Kinked water inlet hose or
clogged inlet lters.
- The water inlet hose must not
be kinked and the relative inlet
lter in the water tap connector
must not be dirty or clogged.
- Water pressure too low. - The water tap must be fully
open during water inlet
(minimum capacity: 0,5 liters per
minute).
...theCANCEL/Offindicator
lampblinks6times/wash
programendedtooearly
(dishesaredirtyandwet)
- Dirty or clogged lters. - The lters must not be dirty or
clogged.
- Too little water in the
dishwasher’s water
system.
- Concave items (e.g. Bowls,
cups) must be arranged facing
downwards in the rack.
- Drain hose incorrectly
tted.
- The drain hose must be tted
correctly (for high mounted
appliances, leave min. 200-400
mm from the lower edge of
the appliance) - see Assembly
Instruction.
- High level of foam inside. - Repeat without detergent or
wait until foam disappears.
...theCANCEL/Offindicator
lampblinks8times
- Dirty lters. - Clean the lters.
- Kinked drain hose - The drain hose must not be
kinked.
- Syphon hose connection
closed.
- The closure disk of the syphon
hose connection must be
removed.
Whattodoif...