- whirlpool UNDERCOUNTER DISHWASHER use & care guide

When the HI-TEMP WASH-
ING option is selected,
water for the main wash
and the final rinse is
heated to 145°F (63°C) -
except in RINSE HOLD.
Washing and rinsing ac-
tion in parts of the cycle will
be longer if the water is
heated. The HOLD-HEAT WATER Signal Light will
be on while water is heating.
l Touch once to select the option. Touch again
if you want to cancel it.
l The Signal Light on the selectorwill be on if HI-
TEMP WASHING is selected.
l The Signal Light will be off if the option is not
selected or if it can’t be used with the cycle
selected; RINSE HOLD.
l You can select or cancel the option during a
cycle by touching the pad.
l The HI-TEMP WASHING Option is not recom-
mended in the CHINA CRYSTAL Cycle.
When the HEAT DRY Selector is touched, air
in the dishwasher is heated
during the “dry” part of any
cycle -except RINSE HOLD.
If the signal light above
the Dry Option Selector is
ON, you will get HEAT DRY. If
the signal light is OFF, you
will get AIR DRY.
The AIR DRY Option helps
save energy, but dishes will
take longerto dry (overnight) and some water
spotting may result. Some items (such as plas-
tics] may need towel drying. For best results,
use a liquid rinse aid such as Jet-Dry.”
You can select or cancel the option during
a cycle by touching the option selector.
Use the DELAY WASH Op-
tion when you want the se-
lected cycle to start later -
from 1 to 9 hours after load-
ing the dishwasher. For ex-
ample, use DELAY WASH to
run the dishwasher during
off-peak hours of electrical
use.
Load the dishwasher; close and latch the
door.
Select cycle and option or options desired.
Touch the START DELAY WASH Selector once
for each hour you want the dishwasher to
delay.
Do not touch START. The selected cycle will
start automatically after the time in the Dis-
play has elapsed.
l You may touch START at any time during the
delay if you want the dishwasher to start
immediately
l Add time during the delay by touching the
selector once for every additional hour of
delay you want.
l Add items to the load at any time during the
delay. Close and latch the door.
Touch the DRAIN OFF
Selector once to stop a
cycle. The dishwasher will
stop and the water will
pump out. This takes about
2 minutes -the Display will
show “02:’
When the draining stops,
a new cycle can be selected. Check the de-
tergent dispenser before starting another
cycle.
Touch the selector twice to cancel DELAY
WASH if you want to cancel delay hours but
not start the machine immediately.
If you cancel instructions during a cycle,the
dishwasher will stop, but wafer will not drain
away. Do not allow water to stand in the
dishwasher.
9