Instruction for Use

Detergent and Rinse Aid ....

Detergent

Detergent specifically intended for use with dishwashers

must be used. The dispenser must be refilled before the

start of each wash cycle following the instructions provided

in the "Wash Cycle Table." The detergent dispenser is

located on the inside panel of the door.

Loading the detergent

To open lid "A", press button "B". The cleaning detergent

should be introduced into the two containers "C"and "D"

up to the rim.

After pouring in the detergent, replace the lid, pressing

down until it clicks.

Dishwasher detergent in tablets is now available on the

market, in which case you should place one tablet into

container "D" and replace the lid.

Notice: To facilitate closing the cover, remove any

excess detergent on the edges of the dispenser.

Rinse Aid

This product makes dishes sparkle more as it improves their

drying. The rinse aid container is situated on the inside of the

appliance door; you should refill it when you see the container

is empty by means of indicator “D”.

(If your dishwasher is fitted with a “low rinse aid” indicator

light, fill the container up when the indicator light flashes or

lights up).

Loading the Rinse Aid

To open the dispenser, turn the "C" cap in the anti-clockwise

direction and then pour in the rinse aid, making sure not to

overfill. The amount of rinse aid used for each cycle can be

regulated by turning the "F" dose adjustor, located beneath

the "C" cap, with a screwdriver. There are 6 different

settings; the normal dosage setting is 4.

Important:

Proper dosage of the rinse aid improves drying.

If drops of water remain on the dishes or spotting occurs,

the dosage adjustor should be turned to a higher setting. If

the dishes have white streaks, turn the dosage adjustor to a

lower setting.

Warning

Three-in-one dishwasher tablets are now available on the market, and combine detergent, salt and rinse aid all in one.

If the water in your area is hard or very hard, we still recommend you pour extra salt into the relevant dispenser to prevent the

formation of white streaks on your dishes or on the interior of the appliance.

Using a three-in-one product means it is no longer necessary to put rinse aid into the relevant container.

If you want to achieve perfectly dry dishes, you may add rinse aid as long as the dosage adjuster is set to no.2.

In any case, please read the manufacturer's instructions on the packet.