GB User and maintenance manual
IMPORTANT SAFETY INSTRUCTIONS These instructions shall also be available on website: docs.whirlpool.eu. YOUR SAFETY AND THAT OF OTHERS IS HIGHLY IMPORTANT. This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the attention symbol, pertaining to safety, which alerts users to potential risks to themselves and others.
• If the hood is used together with other appliances operating on gas or other fuels, the negative pressure in the room must not exceed 4 Pa (4 x 10-5 bar). For this reason, make sure the room is adequately ventilated. • The Manufacturer declines any liability for improper use or incorrect setting of the controls. • Regular cleaning and maintenance is essential to correct functioning and good performance of the appliance.
INSTALLATION After unpacking the appliance, check for any transport damage. In the event of problems, contact the dealer or your nearest After-sales Service. To prevent any damage, only remove the appliance from its polystyrene foam packaging at the time of installation. PREPARING FOR INSTALLATION WARNING: this is a heavy product; the hood should only be lifted and installed by two or more people.
GENERAL RECOMMENDATIONS Before use Remove cardboard protection pieces, protective film and adhesive labels from accessories. Check the appliance for any transport damage. Use only the fixing screws supplied with the product for installation or, if not supplied, purchase the correct screws type. Use the correct length for the screws which are identified in the Installation Guide. In case of doubt, consult an authorised service assistance centre or similar qualified person.
AFTER-SALES SERVICE Before calling the After-Sales Service: 1. See if you can solve the problem yourself with the help of the suggestions given in the "Troubleshooting guide". 2. Switch the appliance off and back on again it to see if the fault persists. If after the above checks the fault still occurs, get in touch with the nearest After-Sales Service.
Maintenance of the charcoal filter It absorbs unpleasant odours caused by cooking. The carbon filter must be washed once a month in a dishwasher at the highest temperature, using a normal dishwasher detergent. Wash the filters on their own. After washing, reactivate the carbon filter by drying it in the oven at 100° C for 10 minutes. Change the carbon filter every 3 years. Fitting the carbon filter: 1. Remove the grease filter. 2. Remove the filter holder by turning the knobs through 90° 3.
TECHNICAL DATA Model Height (cm) Width (cm) Depth (cm) Ø of exhaust tube (cm) 60 -112,5 68,5 - 112,5 59.8 45 15-12,5-12 DGHFG 64 AM X 60 -112,5 68,5 - 112,5 89,8 45 15-12,5-12 DGHFG 94 AM X Please check the plate in order to verify the total absorption and the light absorption.
1x 3x Ø 3,5x9,5 4x Ø 2,9x6,5 1x 1x 1x 6x Ø 5x45 6x Ø 8x40 1x Ø 150 mm 2x M6x20 2x 1x 1x 2x
18
= = = = 1 x Ø 8mm 5mm 2 x Ø 8mm
9,5cm > 1cm Ø 16cm > 5cm X cm > 1cm X - 2cm V ~ Hz > 3cm Ø 16cm
2x M6 x 20mm 2x Ø 14 x 7mm
Printed in Italy 04/2017 GB 400011109502
