Instruction for Use

EN
28
Notes:
Optimumperformancelevelswhenusingthe“Fast"and"Express
40’”cyclescanbeachievedbyrespectingthespecifiednumber
of place settings.
To reduce consumption even further, only run the dishwasher
when it is full.
Note for Test Laboratories:
forinformationoncomparativeEN
testing conditions, please send an email to the following address:
[e-mail]
Half load
If there are not many dishes to be washed, a half
load cycle may be used in order to save water, electricity
and detergent. Select the wash cycle and press the HALF
LOAD button: the indicator light will illuminate.
Press the HALF LOAD button to deselect this option.
Remember to halve the amount of detergent.
Special wash cycles and Options
Delayed start
It is possible to delay the start time of the wash cycle
by 3, 6 or 9 hours:
1:Afterselecting the desired wash cycle and any other
options,press the DELAYED START button.the indicator
light will illuminate.
2:SelectthedesireddelaytimebypressingtheDelayed
Start button repeatedly. The wash phase (3 hours), the
dryingphase(6hours)andend(9hours)indicatorlights
will illuminate in succession.
If the Delayed Start button is pressed again, the option is
deselected and the indicator light switches off.
3. After the selection process, the countdown will begin if
theStart/Pausebuttonispressed.Theselecteddelayperiod
indicatorlight flashes and the Start/Pause button stops
flashing (fixed light).
3.Oncethistimehaselapsed,theDELAYEDSTARTindicator
light switches off and the wash cycle begins.
The Delayed Start function cannot be set once a wash
cycle has been started.
Wash options*
The OPTIONS may only be set, changed or reset after
the wash cycle has been selected and before the Start/
Pause button has been pressed.
Only the options whic are compatible with the type of wash
cycle set may be selected. If an option is not compatible
with the selected wash cycle
(see Table of wash cycles) , the
corresponding symbol flashes rapidly 3 times.
If an option is selected which is not compatible with another
(previously selected) option, it will flash 3 times and switch
off, while the most recently selected option will remain active.
To deselect an option which has been set by mistake, press
the corresponding button again.
* Only available in selected models.