Specifications

A chimney connector shall not pass through an attic, roof space, closet, floor, ceiling, or similar concealed space. Where

passage through a wall or partition of combustible construction is desired or necessary, the installation shall conform to

NFPA 211 or CAN/CSA-B365 requirements.

Whatever brand of chimney system is purchased for your Ovation installation, you must ensure that all chimney

manufacturer’s installation instructions are followed and that all national and local codes have been met.

OUTSIDE AIR COMBUSTION

It is imperative that the installer or homeowner ensures that a minimum of at least eight square inches (fifty square

centimeters) of outside air be admitted to the hearth room or directly to the stove. If installation allows, a four-inch

diameter pipe can be brought in through an exterior wall and connected, using the optional fresh air adapter, directly to a

catalytic stove.

Provision for outside combustion air may be necessary to ensure that fuel-burning appliances do not discharge products of

combustion into the house. Guidelines to determine the need for additional combustion air may not be adequate for every

situation. If in doubt, it is advisable to provide outside air.

Outside combustion air may be required if:

1 A catalytic stove does not draw steadily, smoke rollout occurs; fuel burns poorly, or back-drafts occur whether or

not combustion is present, or

2 Existing fuel-fired equipment in the house, such as fireplaces or other heating appliances smell, do not operate

properly, suffer smoke rollout when opened, or back-draft occurs whether or not combustion is present, or

3 The home is equipped with a well-sealed vapor barrier and tight fitting windows or has any powered devices that

exhaust house air, or

4 There is excessive condensation on home windows in the winter, or

5 A ventilation system is installed in the house.

If any of these or other indicators suggests that infiltration air is inadequate to sustain proper combustion in a catalytic

stove, additional combustion air should be provided from the outdoors. Outside combustion air can be provided to the

appliance by the following means:

Direct connection: appliances can only use direct connection of outside combustion air if they are certified for this type

installation. Follow the Ovation instructions for direct connection of outside combustion air.

Indirect connection: for appliances not certified for direct connection of outside combustion air, outside air can be

ducted to within twelve inches of the appliance.

Mechanical ventilation: if the house has a ventilation system (air change or heat recovery):

A ventilation system may be able to provide sufficient combustion make-up air for a catalytic stove but the homeowner

should be informed that the ventilation system might need to be re-balanced by a ventilation technician after installation

of a catalytic stove.

CHIMNEY INSTALLATION

Install an approved chimney system in an interior chase of a home. A chase is defined as an enclosure (combustible or

noncombustible) that is built to cover the chimney system. Interior chimney systems, with a properly constructed

chase, provide better overall stove performance. Performance is enhanced because the chase maintains heat around the

chimney thereby ensuring improved draft that improves venting (removal of spent exhaust gases.) In areas where

temperatures hover or remain below freezing, the use of an exterior chimney will only increase the likelihood of

problems. Some of these problems will be difficult starts, weak draft, high rates of creosoting, and increased maintenance

of the system. Exterior chimneys are also prone to down drafting and flow reversal. Installations, which are located on

lower floors in the house, such as in a basement, in combination with an exterior chimney are especially prone to flow

reversal.

Always follow the Chimney Manufacturer’s installation procedures over any recommendations this manual provides on

chimney systems. Installing the chimney must be in compliance with local codes, chimney manufacturer’s recommended

procedures, and the chimney must connect to the Country Flame stove in accordance with instructions provided.