Instruction for Use

34
1. The machine is factory-set to make coffee with a standard taste. You can choose coffee with the following tastes:
extra-mild, mild, standard, strong or extra-strong, with the option of using pre-ground coffee. To choose the
desired taste, press the button
(B3) (Figure 8) repeatedly until the required taste is displayed.
2. Place 1 cup under the coffee spouts if you wish to make 1 coffee (Figure 9) or 2 cups for 2 coffees (Figure 9). For a
creamier coffee, lower the coffee spout as near as possible to the cups (Figure 10).
3. Press button
(B4) (Figure 11) to select the type of coffee desired: espresso, small cup, medium cup, large cup,
mug.
Press button
(B8) (Figure 12) to make 1 coffee, or button (B9) (Figure 13) to make 2 coffees. The machine
grinds the coffee beans and then runs off the coffee.
After running off the pre-set quantity of coffee, the machine automatically stops run-off and then empties the coffee
grounds into the grounds container.
4. After a few seconds, the machine is once again ready for use.
5. To switch off the machine, press the on/stand-by button (A7) (Figure 1). (Before switching off, the machine runs an
automatic rinse cycle: beware of the danger of burns).
N.B.:
• If coffee run-off is too slow or incomplete, refer to chapter ADJUSTING THE COFFEE GRINDER.
• If coffee run-off is too quick and the coffee is not creamy enough, refer to chapter ADJUSTING THE COFFEE
GRINDER.
• Tips for hotter coffee:
- proceed as described in chapter CHANGING AND SETTING MENU PARAMETRS, function Rinsing;
- do not use very thick cups as they absorb too much heat unless pre-heated in advance;
- use pre-heated cups, rinsing them with hot water.
• You can interrupt run-off any time by pressing the previously selected button again.
• As soon as run-off is finished, to increase the amount of coffee in the cup, simply press and hold the previously
selected button within 3 seconds of completion of run-off).
• When the display shows FILL TANK! the water tank must be filled, otherwise the machine will not prepare any
coffee. (The tank may still contain some water; this is normal).
• Every 14 single coffees (or 7 doubles) made, the display shows the message EMPTY GROUNDS CONTAINER!.
To clean, open the service door on the front by pulling the spout (Figure 16), then remove the drip tray (Figure 17)
and clean it.
When cleaning the machine, always fully remove the drip
tray.
• When removing the drip tray, the grounds container
MUST be emptied. If this is not done, the machine
may clog up.
• The water tank must never be pulled out during coffee run-
off. If the tank is removed at this point, the machine cannot
make the coffee and will display the message: GROUND
TOO FINE. ADJUST MILL! PRESS ‘OK’ followed by FILL
TANK!. Check the water level in the tank and replace in
the machine. To restart the machine, insert the water spout
if not already inserted (Figure 6), press
(B7) and the
display shows HOT WATER. PRESS ‘OK’. Press
(B7)
within a few seconds, let water run off from the spout for around 30 seconds. After run-off, the machine display
automatically reverts to the programmed standard settings.
• The machine may require you to repeat the operation several times; this is in order to eliminate any air in the
hydraulic circuit.
• If the above described operation is not carried out correctly or if the machine is switched off, the display may
revert to showing the programmed standard settings, even if in actual fact the problem persists.
Making coffee (using coffee beans)