Operation Manual

36
DRAIN HOSE
•
Drain hose connection to water outlet.
1.
Unhook the drain hose from the left clip, see arrow
A in Fig. 1.
Do NOT loosen the right drain hose connection,
see arrow B in Fig. 1, otherwise there is the risk of
leakage (danger of scalding with hot water).
2.
Fit the drain hose either to the siphon or hook it
over the edge of a sink or bath tub with the “U”
bend (Fig. 2). Small hand basins are not suitable.
The edge of the tub must be no higher than 125 cm
above the floor.
3.
Minimum drain height: 70 cm.
Maximum drain height (“U” bend): 125 cm.
4.
If you need to add an extension, use a flexible
hose of the same type and secure the union with
screw-on hose clips.
Maximum overall drain hose length 2.5 m.
Important
Make sure that there are no kinks in the drain hose run
and take precautions against it falling while the
appliance is running (Fig. 2).
CONNECTION TO THE MAINS
•
Observe local utility company regulations.
•
The connection must be made with a correctly
installed, earthed and insulated socket.
•
The system must be earthed by law.
•
The manufacturer declines all responsibility for
injury to persons or pets and damage to property
caused by disregarding the above instructions.
•
The data concerning voltage, consumption and
electrical protection are supplied on the inside of
the appliance door.
•
The mains connection cable may only be replaced
by a qualified electrician.
•
The appliance conforms to European safety
regulations, EC directive 93/68 EWG and
EN 60555.
•
Do not use extension leads or multisockets.
INSTALLATION INSTRUCTIONS
Fig. 1
Fig. 2