Installation Guide

REVERSING DRYER DOOR SWING (OPTIONAL)

3. Move hinge to other side. Reinstall 4 screws.

4. Reinstall plug strips on opposite side of the inner door.

5. Check for ngerprints on the glass. Clean if necessary.

Replace the Door Assembly

1. Place the inner door assembly inside the outer door

assembly.

2. Reassemble the inner and outer door assemblies with

the 6 screws.

Reverse the strike

1. Use a small at-blade screwdriver to remove plug strip from

the dryer door opening. Slide the head of the screwdriver

under the plugs, without scratching dryer surface, and lift

up strip.

2. Remove the strike using a Phillips screwdriver.

3. Insert strike on the opposite side.

Reinstall the door

1. Partially insert the third screw from the top; then slide the

hinge onto this screw while hooking the hinge into the front

panel hole. Reattach door to dryer front panel with the

remaining three screws.

2. Check for ngerprints on the glass. Clean if necessary.

3. Close door and check that it latches securely.