Setup and user guide

2
DAILY USE
FUNCTIONS
TEMPERATURE SETTING
Press the Temperature button on the control panel to
adjust the temperature from the warmest through the
lower to the coldest level.
Pressing the Temperature button, the temperature setting
will change cyclically.
At rst plug-in of appliance temperature setpoint is present
at medium position (factory setting).
Following table shows temperature setpoints:
HIGH TEMP.
MEDIUM TEMP.
LOW TEMP.
MED-HIGH TEMP.
MED-LOW TEMP.
FAST COOLING
Led on Led o
Note: Displayed set points correspond to the average
temperature throughout the whole refrigerator.
FIRST TIME USE
HOW TO START THE APPLIANCE
After plugging the appliance to the mains, it starts the operation
automatically.
After starting the appliance, wait at least 4-6 hours before placing
food into the fridge and into the freezer compartment.
When the appliance is connected to the power supply, the display
lights up and all the icons appear on the display for approximately 1
second. The default (factory) values of the fridge compartment
settings light-up.
ACCESSORIES
See Use and Care Guide for more details on functions /
see last page for information on how to obtain the Use and Care Guide
EGG TRAY BOTTLE SEPARATOR ICE TRAY
STOP FROST ACCESSORY
6TH SENSE
This function automatically works to ensure the optimal conditions
to preserve the stored food.
The “6th Sense” function is automatically activated when:
• a large amount of food is loaded into the refrigerator
• the refrigerator door is left open for a long time
• a prolonged power failure takes place, causing the internal
temperature of the appliance to increase to values that cannot
guarantee safe storage of food.
FAST COOLING
The use of the Fast Cooling function is recommended to increase
the cooling capacity of the refrigerator compartment when placing
a very high quantity of food within it.
To activate the Fast Cooling function, press and hold for 3 seconds
the Temperature button on the control panel till all the 3 LEDs will
turn on.
The function is automatically deactivated after 24 hours and return
to previous selected set point.
!
!
!
The function can be manually deactivated by pressing and holding
for 3 seconds the Temperature button on the control panel.