Instruction for Use

15
TROUBLESHOOTING GUIDE
The oven does not work:
•
Check the power supply and that the oven is
connected.
•
Switch the oven off and then on again to see if the
fault has been eliminated.
If the door is blocked:
•
Switch the oven off and then on again to see if the
fault has been eliminated.
IMPORTANT:
•
Make sure the oven control knob is not turned to
“0”.
•
If the electronic programmer indicates “ ”,
consult the separate Product Sheet and/or the
electronic programmer description.
•
If the electronic programmer indicates “
.
HH”,
contact the nearest After Sales Service. In this
case specify the number after the letter “
.
”.
AFTER-SALES SERVICE
Before calling the After-Sales Service:
1.
See if you can eliminate the problem on your
own, according to the steps described in
“Troubleshooting Guide”.
2.
Switch the appliance off and then on again it to
see if the problem has been eliminated.
If the fault persists after the above checks,
contact the nearest After-Sales Service.
Always specify:
•
a brief description of the fault;
•
the type and exact model of the oven;
•
the service number (number after the word
Service on the rating plate), located on the
inside right edge of the oven compartment
(visible with the door open). The service
number is also given in the warranty booklet;
•
your full address;
•
your telephone number.
•
If any repairs are required, contact an
Authorised After-Sales Technical Service
Centre (to guarantee the use of original spare
parts and correct repair).
•
Failure to comply with these instructions can
compromise the safety and quality of the
product.
DECLARATION OF CONFORMITY
• This oven is intended to come into contact
with food products and complies with
regulation (EC) no. 1935/2004.
• It is designed only for use as a cooking
appliance.
Any other use (e.g. for room heating) is
considered improper and therefore
potentially dangerous.
• This appliance has been designed,
manufactured and put on the market in
compliance with:
- The safety requirements of
“Low Voltage” Directive 2006/95/EC
(replacing 73/23 EEC as amended).
- The protection requirements of “EMC”
Directive 89/336/EEC.
- the requirements of Directive 93/68/EEC.





41056280GB.fm Page 15 Wednesday, September 19, 2007 5:24 PM