Instruction for Use

DOOR REVERSIBILITY

For your convenience:

In case you want to stack the dryer on a washing machine, you can

reverse the door opening direction, to bring the door handle in a

lower position.

A. Unplug the dryer.

B. Open the door.

C. Using a pliers, turn the contact pin (B) in the upper part of the door by

90° and pull it out.

D. Removing the door lock:

Unscrew the 2 screws above and below the door lock system.

E. Press the small knob above the door lock system with a small

screwdriver, move the door lock a little bit upwards and pull the door

lock towards you with your finger.

F. Reverse the door:

Remove the two screws of the door fixation.

Fasten the door again on the desired side with the 2 screws.

Take care to screw in horizontal position to avoid pinching off the door

seal.

G. Repositioning of the door lock:

Insert the door lock on the opposite side of the door fixation. Press it

completely inside the hole and move it a little down, until the small

knob of the door lock system is latching.

H. Fix the two screws above and below the door lock system.

I. Replace now the contact pin in the inside of the door on the top side,

by inserting it and turning it again for 90°.

NOTE:

Please use a screw driver of the type “Torx T20”.