Instruction for Use

65
Home
Appliances
INSTALLATION
Removing the transit bolts
1.
Slacken and remove the screws “
A
” which lock the drum
during transport by following the instructions given at
the side.
2.
Insert a screwdriver into the empty holes and tilt to
remove the plastic spacers “
C
” (transit bolts) and retrieve
them.
3.
Keep the transit bolts for future use.
If the spacers remain inside the machine: open the rear
panel by removing the screws “
B
” remove the spacers and
replace the panel.
Fit the transit bolts before transporting the appliance as
follows:
1.
Disconnect the plug, remove the inlet and drain hoses.
2.
Uscrew fixing screws “
B
” on the rear panel and remove it.
3.
Insert the four screws “
A
” of the safety catch in the four
rubber bushes, then put the four spacers “
C
” on the
screws behind the panel.
4.
Position the rear panel on the appliance, first tighten the
four screws “
A
” of the safety catch for transportation to
the rear part of the tub, then use screws “
B
” to fit the
panel to the appliance.
B
A
B
A
A
A
C
C
3Gb20102.fm5 Page 65 Tuesday, January 15, 2002 3:05 PM