Installation

Adjust the feet
If the floor is uneven, adjust the levelling feet as required
(do not insert pieces of wood etc. under the feet):
1. Slacken the locknut using the spanner supplied.
2.Adjust the height of the foot, turning it by hand.
3.Tighten the locknut by turning it anti-clockwise towards
the appliance casing.
If the appliance is to be installed on a wooden floor,
distribute the weight by placing it on a 60 x 60 cm sheet
of plywood at least 3 cm in thickness.
Secure the plywood sheet to the floor.
Worktop for built-under models
The appliance must only be installed beneath a continuous fitted kitchen worktop.
If the appliance will be built under it is mandatory
to use the cover panel UBS. This can be obtained
from specialist shops or from After-Sales Service.
1. Unplug the appliance.
2.Unscrew the worktop fixing screws from the rear of the appliance.
3.Slide the worktop fully backward and lift it upwards to remove. Install the cover panel following the
relative instructions.
4.Refit the fixing screws and tighten them.
5.Plug the appliance only into the mains power socket.