Instruction for Use

27
The appliance will not switch on.
• Power plug properly inserted in mains
socket?
• Mains fuse OK?
• Power failure?
• Tap turned on? Is water coming through?
• Door closed?
• Programme selected?
• Appliance switched on?
No water or insufficient water supply.
• Tap turned on completely?
• Kink in water hose?
• Water hose filter clogged? (See “Care and
Maintenance”).
• Water hose frozen up?
Waste water not pumped out.
• Drain hose installed correctly? (See
“Installation”).
• Filter clogged? (See “Removing the filter”/
“Draining residual water”).
• Drain hose frozen up?
• Is the rinse hold button pressed?
Detergent and additive product residues in
detergent drawer at end of wash.
• Siphon installed correctly?
• Siphon clogged?
• Not enough water delivered? (See above).
• Also see “Detergent and Additives” and
“Care and Maintenance”.
Machine vibrates during spin cycle.
• Machine perfectly horizontal with all four feet
on ground? (See “Installation”).
• Transit screws and bar removed? The transit
screws and bar must be removed before the
machine is used (see “Installation”).
Final spin results are poor.
• Pump impeller obstructed? (See “Removing
the filter”/“Draining residual water”).
Before contacting After-Sales Service:
1. Try to remedy the problem
(see “TroubleShooting Guide”).
2. Restart the programme to see if the fault is
repeated.
3. If the malfunction persists, call After-Sales
Service and specify:
• The nature of the problem.
• The exact model of the appliance.
• The service code
(number after the word SERVICE).
The After-Sales Service sticker is on the inside
of the door.
• Your full address.
• Your telephone number and area code.
• The After-Sales Service telephone number
and address can be found in the warranty or
on application to the retailer.
TROUBLESHOOTING GUIDE
AFTER-SALES SERVICE
00004-gb.fm5 Page 27 Wednesday, May 10, 2000 3:35 PM