Instruction for Use

21
WASHING PROGRAMME
Select the programme:
1.
Check that the
Programme Selector
is on 
Stop
.
2.
Plug in the appliance.
3.
Open the tap.
4.
Set the
Programme Selector
to the desired programme.
5.
Depending on model, set the
Temperature Selector
knob to the desired temperature.
6.
Depending on model, set the
Spin Speed Selector
knob to the desired spin speed.
7.
Select the
options
desired by pressing the corresponding buttons.
By a further pressing of the button this option can be turned off again.
8.
Check that the door is well closed. Press the
On/Off
button. The indicator lamp lights up.
Attention: During the selected washing programme the programme selector knob moves by steps
clockwise. Never force it in the opposite direction.
Door lock
The door locks automatically after the programme start until the end of the programme.
If the programme selector is moved to the Stop position or if the electricity supply is interrupted,
then the door is released after approximately two minutes.
In this case do not open the door: because hot water could come out of the door.
Programme end
The programme selector knob is at the stop position.
1.
Press
On/Off
button . The indicator light turns off .
2.
Cancel the special options by pressing the appropriate buttons.
3.
Turn off the tap.
4.
Wait for the door to unlock (about 2 minutes).
5.
Open the door and unload the machine.
N.B.
Do not fully close the door but leave it ajar to allow the drum to dry out.
Changing programme
1.
Press
On/Off
button . The indicator light turns off .
2.
Select the new programme.
3.
Press
On/Off
button . The new program will re-start.
Do not add detergent for this programme.
Programme interruption or pause
To interrupt the running programme for a certain period and continue it at a later time:
1.
Press
On/Off button
.
2.
Following the desired pause press the
On/Off
button again.