Installation guide
CONDUITKIT/JUNCTIONBOX
INSTAHATION INSTRUCTIONS
• Power supply wires must be located within 30 in. (76.2 cm) of
conduit exit from chassis.
Tools needed
• Flat-blade screwdriver
Parts supplied
• Wire harness
• Flexible conduit
• Junction box
• Junction box cover
• Bushing
• Straight connector
• Right angle connector
• Wire nuts
• Unpack and dispose of packaging materials.
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
Electrical Shock Hazard
Electrically ground PTAC/PTHP.
Connect ground wire to green pigtail lead.
Use copper wire for supply connection.
Correct wire gauge is shown in the chart below.
Failure to follow these instructions can result in
death or electrical shock.
Rating Plate Ampacity
Less than 15
16 - 20
21 - 30
AWG
14
12
10
1. Disconnect power.
17