Installation guide

7. Install the front cover by placing the top of the front cover

onto the metal flange at the top of the chassis. Rotate the

front cover into place.

8. Thread the thumbscrews through the drilled holes in the front

cover into the screw clips to secure the front cover to the

chassis.

CONTROLS

NOTE: For remote wall thermostat controlled models, see

"Remote Wall Thermostat Installation Instructions."

Temperature Control

Turn the temperature control knob to a mid setting. Adjust the

performance of the PTAC/PTHP by turning the temperature

control knob clockwise (until it stops) for maximum cooling and

counterclockwise (until it stops) for maximum heating.

Experiment to find the setting that suits you best.

NOTE: Cooling will not begin if the room temperature is below

60°F (15.6°C). Heating will not begin if the room temperature is

above 90°F (32.2°C).

Fan Control

Set the fan control to the desired setting.

Low Cool Use this setting for sleeping comfort.

High Cool Use this setting for maximum cooling.

Low Heat Use this setting for sleeping comfort.

High Heat Use this setting for maximum heating.

Fan Only Use this setting for circulating air without

heating or cooling.