Installation guide

FRONTCOVERSIDEMOUNTKIT

INSTAHATION INSTRUCTIONS

NOTE: Unpack and dispose of packaging materials.

Kit Installation

1. Remove front cover.

2. Locate the indent on the inside lower back corners of the

front cover and drill a %6 in. hole in the indent on each side.

4. Loosen the 2 screws on the bottom of each side bracket.

NOTE: Do not remove these screws.

1. Indent - inside view

2. Front of front cover

Remove the screw clip from the bottom of each side bracket.

Save it for reinstallation.

!. Side-bracket screws--loosen; do not remove

5. Slide the appropriate mounting bracket onto the side-bracket

screws and tighten the screws.

6. Install the screw clip onto the mounting bracket with the

smooth side facing the outside. Repeat on the other bracket.

1. Screw clip

!. Screw clip

2. Mounting bracket