Installation guide

STANDARDGRILLEINSTALLATIONINSTRUCTIONS

NOTE: Unpack and dispose of packaging materials.

1. Remove the center support and weatherboard, if still installed

in the wall sleeve.

Grasp the grille by the attached plastic handles. Position it

with the condensate drain knockouts facing down. From the

inside of the building, maneuver the grille through the wall

sleeve and pull toward you until the screw heads are inserted

into the keyhole slots at the top of the wall sleeve. Tighten the

2 screws.

!. Wall sleeve

2. Weatherboard

3. Center support

Insert 6 plastic grommets into the outdoor grille openings

from the outside of the grille.

2 ¸

!. Plastic handles

2. Plastic grommets

3. Condensate drain knockouts

Insert the remaining screws into the remaining holes and into

the grommets and tighten all screws.

1. Plastic handles

2. Plastic grommets

3. Condensate drain knockouts

Insert 2 - #8 x % in. sheet metal screws (provided) in the top

2 outside edge plastic grommets. Tighten the screws halfway

into the grommets.