Instruction for Use

5019 318 33227
1. Control panel.
2. Grease filters or grille.
3. Lighting unit.
4. Pull-out steam deflector.
5. Filter or grille release devices.
Removing and renewing or washing the grease
filter:
1. Unplug the appliance or disconnect the power supply.
2. Pull out the steam deflector (
1 - Fig. 1
).
3. Open the grille or grease filters (
2,3 - Fig. 1
).
4. For hood version with grille: Remove the device securing the
grease filter (
Fig. 5
).
5. Remove the dirty grease filter.
6. After the grease filter has been replaced or cleaned (depending on
model), refit the parts in reverse order, making sure the entire
extraction surface is covered.
Fitting or replacing the carbon filter:
1. Unplug the appliance or disconnect the power supply.
2. Pull out the steam deflector (
1 - Fig. 1
).
3. Open the grille or grease filters (
2,3 - Fig. 1
).
4. If the filters are not fitted:
Fit the carbon filter over the motor-rotor protection grille and
turn clockwise until locked
(
Fig. 6
).
5. If the carbon filter is already fitted and needs replacing, turn the
carbon filter anticlockwise.
6. Refit the extractor grille or grease filters.
Replacing bulbs:
1. Unplug the appliance or disconnect the power supply.
2. Pull out the steam deflector (
1 - Fig. 1
).
3. Open the grille or grease filters (
2,3 - Fig. 1
).
4. Remove the burnt-out bulb.
5. Use 40W max. (E14) bulbs only.
6. Refit the extractor grille.
CONTROL PANEL
Light: move the switch to the right or press the next button to
switch on.
Extraction speed: Move the switch to the right or press the next
button to increase extraction speed.
With light and speed selected, the hood switches on when the steam
deflector is opened, and switches off when it is closed.
Fig. 3
Fig. 5
Fig. 6
PRODUCT DESCRIPTION SHEET
D F NL E
GB
P I GR
N
S
FIN
DK