Instruction for Use

INSTALLATION - ASSEMBLY INSTRUCTIONS
The instructions below, to be carried out in the order in which they are numbered, refer to the gures (with the same step numbers) given on the last pages of
this manual.
1. Prepare the cut-out on the back of the wall unit, corresponding to the overall dimensions of the hood
60 cm = 260X493
90 cm = 260X693
2. Prepare the hole at the top for the exhaust pipe Ø150
3. Fit the exhaust pipe connector (using the two 3.5x9.5 screws provided)
4. Remove the protective lm from the lateral adhesive strips
5. Slide the hood inside the wall unit
6. The lateral snap-in supports will return to the outside, allowing to fasten the hood to the wall unit
7. Secure the xing by tting n°.4 screws (two each side) to each side support:
16mm screw, for wall units 15 to 20mm thick,
12mm screw for wall unit above 20mm thick
Note: when fastening, apply a light pressure on the hood body, in order to facilitate the lateral adhesive gripping
8. Fit n°.4 screw caps
9. Connect the hose (to be purchased separately) for venting the exhaust fumes; if necessary, use the multi-connection ange to reduce the aperture to
ø125-120
For Extractor Version only: feed the hose towards the exterior
For lter versions only: t the ow-diverter grille (to be purchased separately) to the top of the of the wall unit
10. Open the perimeter extraction panel and remove the grease lter,
11. For lter version only: insert the carbon lters (refer to instructions in the section MAINTENANCE-Carbon Filter)
12. Ret the grease lter
13. Close the perimeter extraction panel