(Apply the label from warranty here) EN IT EL DA User and maintenance manual Manuale d’uso e manutenzione Manuel d’utilisation et d’entretien Benutzer- und Wartungshandbuch Manual del Usuario y de Mantenimiento Εγχείριδιο χρήσης και συντήρησης Vejledning i brug og rengøring Manual de manutenção para o utilizador
IMPORTANT SAFETY INSTRUCTIONS YOUR SAFETY AND THAT OF OTHERS IS VERY IMPORTANT This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the danger symbol, pertaining to safety, which alerts users to potential risks to themselves and others. All safety warnings are preceded by the danger symbol and the following terms: DANGER Indicates a hazardous situation which, if not avoided, will cause serious injury.
INSTALLATION After unpacking the oven, be sure that it has not been damaged during transport and that the oven door closes properly. In the event of problems, contact the dealer or your nearest After-sales Service. To avoid any damage, only remove the oven from its polystyrene foam base at the time of installation. PREPARING THE HOUSING UNIT • • • • Kitchen units in contact with the oven must be heat resistant (min 90°C).
TROUBLESHOOTING GUIDE The oven does not work: • • Check for the presence of mains electrical power and if the oven is connected to the electrical supply. Turn off the oven and restart it to see if the fault persists. The door will not open: • • Turn off the oven and restart it to see if the fault persists. IMPORTANT: during self-cleaning, the oven door will not open. Wait until it unlocks automatically (see paragraph “Cleaning cycle of ovens with pyrolysis function”).
Cleaning the rear wall and catalytic side panels of the oven (if present): IMPORTANT: do not use corrosive or abrasive detergents, coarse brushes, pot scourers or oven sprays which could damage the catalytic surface and ruin its self-cleaning properties. • Operate the oven empty with the fan-assisted function at 200°C for about one hour • Next, leave the appliance to cool down before removing any food residue with a sponge. MAINTENANCE - WARNING Use protective gloves.
REPLACING THE OVEN LAMP To replace the rear lamp (if present): 1. Disconnect the oven from the power supply. 2. Unscrew the lamp cover (Fig. 6), replace the lamp (see note for lamp type) and screw the lamp cover back on (Fig. 7). 3. Reconnect the oven to the power supply. Fig. 6 Fig. 7 N.B.: - Only use 25-40W/230V type E-14, T300°C incandescent lamps or 20-40W/230 V type G9 T300°C halogen lamps (depending on model). - Lamps are available from our After-sales Service.
COMPATIBLE ACCESSORIES (for the accessories supplied with oven refer to the tech fiche) Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 7 Fig. 8 6a 6b Fig. 5 Fig. 6 Fig. 9 Drip-tray (Fig. 1) For collecting fat and bits of food when placed under the wire shelf, or as a plate for cooking meat, chicken and fish, etc., with or without vegetables. Pour a little water into the drip-tray to avoid spatters of fat and smoke. Baking tray (Fig. 2) For baking biscuits, cakes and pizzas. Wire shelf (Fig.
CONTROL PANEL DESCRIPTION 4 1 1. 2. 3. 4. 2 3 Function selector knob Minute minder knob Thermostat knob Red thermostat led. HOW TO OPERATE THE OVEN The minute minder allows a time between 1 and 60 minutes to be set. To set the minute minder, first turn it clockwise all the way round and then set it to the desired time. Once the set time has elapsed, a signal sound will be emitted.
COOKING TABLE Recipe Preheating Shelf (from bottom) Temp.
Recipe Function Preheating Shelf (from bottom) Temp.
10/2011 GB IT FR 5019 610 01321 GR DK PT DE Whirlpool is a registered trademark of Whirlpool, USA ES
