Instruction for Use

ManualsBrandsWhirlpool ManualsDishwashersADPU 751 IX

EN -1-

Chart

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!

5019 300 02424

FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.

CANCEL/OFF

BUTTON

Push this button to

switch off the control

panel.

If pressed for 3 seconds

when a program is

running it cancels this

program. If pressed for

3 seconds when the

dishwasher is off, it

drains the water out. If

pressed during program

and delayed start

selection it cancels the

selection and returns to

previous cycle and

option selection.

ECO PROGRAM

INDICATOR

When lit, it indicates that

standard program is active.

MULTIZONE

INDICATOR

When lit, it indicates the

wash in the upper or lower

rack only.

KEYBOARD LOCK

INDICATOR

When lit, it indicates that

keyboard lock is active.

WATER TAP CLOSED

- Alarm

Blinks when there is no inlet

water or water tap is closed.

WASH TIME DISPLAY

Indicates the cycle duration and the remaining time (h:min). With “Delayed start”

selected it indicates the time remaining until program start: “h24” if above

10 hours delay time remain and “h:mm” if below 10 hours delay time remain.

If “Fx Ey” messages appears on the display, see page 9 - chapter “What to do if...”.

DELAY INDICATOR

When lit, it indicates that delay is

active.

SALT INDICATOR

When lit (at the end of the

cycle), the salt reservoir needs

to be refilled.

TABLET

SETTING

This setting allows to

optimize the cycle

performances

according the type of

detergent used. Push

the Tablet button (the

indicator lights up) if

you are using the

combined detergents

in tablet.

If you are using powder

or gel detergent, the

Tablet indicator on the

control panel has to be

off.

MULTIZONE

Allows you to choose

the washing zones.

The appliance washes

both racks by default

(indicators are not lit).

To wash only in specific

rack, press this button

repeatedly:

KEYBOARD LOCK

This option allows you to

lock the buttons on the

control panel.

Children will not be able

to accidentally start the

dishwasher by pressing

the buttons on the

control panel when this

option is selected.

If you want to activate

this option hold down the

button for

3 seconds.

Repeat the same

operation to unlock the

panel.

only upper rack

(including cutlery

rack) indicator lit

only lower rack

indicator lit

DELAYED START

BUTTON

Push the button (repeatedly)

to delay the start of the

program. Adjustable from

0:30 to 24 hours. With each

press of the button, the delay

start increases by: 0:30 if

selection below 4 hours,

1:00 if selection is below

12 hours, 4 hours if selection is

above 12 hours. If 24 hours

reached, and the button is

pressed, the delayed start is

deactivated - "OFF" message is

shown. Then press the START

button. The delay time can be

adjusted after Start key press.

The dishwasher will start after

the set time.

POWERCLEAN

Thanks to the additional power

jets this option provides a more

intensive and powerful wash in

the lower rack, in the specific

area.

START/PAUSE/

RESUME

BUTTON

Push this button to

start the selected

program: the

indicator lights up and

goes off at the end of

the program.

Press Start button or

open the door during

washing cycle to

pause the cycle - the

Start Indicator blinks.

To resume the cycle

push Start button and

close the door.

RINSE AID

INDICATOR

When lit (at the end of the

cycle), the rinse aid dispenser

needs to be refilled.

ANTIBACTERIAL

RINSE

This function activates an

antibacterial rinse at the end of

the wash cycle, guaranteeing a

further reduction of bacteria.

Press the button to activate or

deactivate the function.

This function can be used with

the programs indicated in the

table of programs.

The dishwasher door must be

kept shut for the entire

duration of the program in

order to guarantee reduction

of bacteria.

If the door is opened the

indicator lamp starts flashing.

PROGRAM

SELECTION

BUTTON

Push “P” button

(repeatedly) until

selected program

number is shown on

the display (P1...Px) -

see “Table of

programs” - next

page.

After 3 seconds the

cycle remaining

time is displayed.

Quick reference guide

Whirlpool is a registered trademark of Whirlpool USA

Summary of content (12 pages)

PAGE 1
Chart Quick reference guide BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS! FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED. WASH TIME DISPLAY ECO PROGRAM INDICATOR When lit, it indicates that standard program is active. Indicates the cycle duration and the remaining time (h:min).
PAGE 2
Chart Quick reference guide Table of programs Available options Loading instructions 40-70°C Delay Multizone PowerClean® Antibacterial rinse Use for normal soiled dishes with dried-on food. Senses the level of soiling on the dishes and adjusts the program accordingly. When the sensor is detecting the soil level an animation appears in the display and the cycle duration is updated. The PowerClean® option is activated automatically with this program.
PAGE 3
First time use How to set water hardness in order to always assure the best cleaning results Water hardness should be set before the first wash or if water hardness has been changed Water hardness level is factory set for medium-hard water (level 4). 1. Ask your water supply company what the water hardness is... When powder or gel detergent is used, regeneration salt must be added and water hardness level must be set as indicated in the table on the right.
PAGE 4
Daily check Adding rinse aid (not necessary when you use tablets). How to adjust the rinse aid dosage regulator 2 Visual indicator If required, open the cover B (press the dedicated button). Check the rinse aid indicator to check the level into the dispenser. The rinse aid dosage can be adjusted to the detergent used. The lower the setting, the less rinse aid is dispensed (factory setting: position 4). Press the button to open the cover B.
PAGE 5
How to load the racks Cutlery rack 4 Long tools can be loaded in the frontal part of the rack (if long tools do not fit in the cutlery rack they can be placed on foldable flaps in upper rack). Load long knives with the handle in the left side. How to remove cutlery rack (if available) - It could be useful to remove cutlery rack to load stem glasses in upper rack. - Open the two retainers (H) to take off the rack. When the cutlery rack is in place the retainers must always be closed.
PAGE 6
How to load the racks Upper rack 4 In the upper rack you can load glasses, cups, bowls and, in the right side of the rack, you can load the dessert dishes. Foldable flaps (A) when open help to load stemmed glasses, long utensils or coffee cups. Plate holders (B) can be folded down to load bowls.
PAGE 7
How to load the racks Lower rack 4 In the lower rack plates and pots can be loaded. Vertical plate holders (E) can be folded down to create more space to load pots. When the “Half load/Multizone” option is selected the cutlery basket - F (provided in some models) can be placed in the lower rack. F E How to use PowerClean® ® PowerClean uses the special water jets in the rear of cavity to wash more intensively the high dirty items. 5 1.
PAGE 8
Select program 6 Overview of programs The max. possible number of programs is illustrated in the chapter “Chart”. The corresponding programs for your appliance can be found on the panel (page 1). Choose program according to the attached table of programs (page 2). Duration of the program depends on the external conditions in the apartment, temperature and pressure etc. For hygienic reasons it is recommended to run a high-temperature cycle (e.g. Intensive 65) at least once per month.
PAGE 9
What to do if... If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. The appliance... Possible causes... Solutions... salt indicator is lit - Salt reservoir is empty. (After refill the salt indicator may remain lit at the end of the several - Refill reservoir with salt (for more information - see page 3).
PAGE 10
What to do if... Crockery and cutlery... ...are not perfectly clean/have food residues ...have deposits: regeneration salt residue ...are not dry Possible causes... Solutions... - Too little space between dishes (incorrect arrangement of the concave items in the rack). - Arrange crockery so that items do not touch each other. Concave items (e.g. bowls, cups) must be arranged facing downwards in the rack. - Too little detergent; detergent too old or incorrectly stored.
PAGE 11
What to do if... Crockery and cutlery... Possible causes... Solutions... ...have discoloured plastic parts - Tomato/Carrot juice. - Tomato sauce, for example, can lead to discolouring of plastic parts. Powder detergent is recommended as it allows slightly higher doses to be used for improved whitening. Programs with higher wash temperatures should be used. ...opaque glasses, etc. - Dishes unsuitable for washing in dishwashers (porcelain), ...
PAGE 12
Precautions and general recommendations 1. Packing The packaging materials are 100% recyclable and marked with the recycling symbol . 2. Removing the packaging and inspecting the contents After unpacking, make sure that the dishwasher is undamaged and that the door closes correctly. If in doubt, contact a qualified technician or your local retailer. 3. Before using the dishwasher for the first time - The appliance is designed to operate with a minimum ambient temperature of 5°C.