Operation Manual

ManualsBrandsWhirlpool ManualsDishwasheradp quality

From a water hardness category of 1-2

(average), before using the dishwasher, fill the

salt container with regeneration salt (to find out

the hardness level of water in your area, contact

your local Water Board or check the last bill you

received).

If the water hardness level does not correspond

to position 3 on the selector (setting on delivery)

or if the water hardness level changes:

Turn the selector to the correct position.

Set the water hardness by turning the selector (if

fitted) inside the door (top left) using a screwdriver.

Use the table below to set the dial to the correct

setting:

If the water hardness level falls within category

1 (soft), no salt is required.

How to fill the salt container

Warning:

only use regeneration salts for

use in domestic dishwashers!

Do not fill the salt container with unsuitable

substances, such as detergent, as this will

cause irreparable damage to the water

softener system.

Remove the lower rack.

Unscrew the cap by turning it counter-

clockwise.

When first using the dishwasher: fill the salt

container to the rim with water.

Fill the salt container to the rim with salt

(using the filler provided) (when filling for the

first time use min. 1.5 kg and max. 2 kg) and

stir with a spoon handle.

Screw the cap back on by turning it

clockwise.

Fit the lower rack.

After filling the regeneration salt container,

immediately

start a wash program (the

Prewash program alone is not sufficient), so

as to eliminate any residual saline solution

straight away.

Check the salt level regularly.

Salt level indicator

The dishwasher is equipped with an electric or

visual salt level indicator (depending on the

model installed).

Electric indicator:

The salt level indicator lamp on the control

panel lights up when the salt container is empty.

Visual indicator:

The float is clearly visible in the cap window

when the salt container is full.

The float lowers and is no longer visible when the

salt container is empty.

HOW TO FILL THE SALT CONTAINER

Hardness