Instruction for Use

GB
-8-
Switch off the appliance Everything o.k. ...
Wash cycle
Select program
Quick, permanent or alternating
6
7
8
Exercise caution when opening the door: beware of hot steam.
Only press the button once to turn the appliance into Standby mode.
All the indicator lamps switch off. Unload the appliance, starting from the lower rack in order to avoid any residual drips of water falling onto crockery below.
Maintenance and care
Maintenance and care
Overview of programs
The max. possible number of programs is illustrated in the chapter “Chart”. The corresponding programs for your appliance can be found on the panel (page 1).
Choose program according to the attached Table of programs (page 2).
Duration of the program depends on the external conditions in the apartment, temperature and pressure etc.
The dishwasher door must be closed and the water tap open.
To pause the program (e.g. if you want to insert an item):
- Open the door with caution (the program pauses) and insert
the item/s,
(beware of HOT steam!)
.
- Close the door and press the
START
button again to restart
the cycle (the program resumes the cycle from where it was
interrupted).
To Cancel the program on running:
- Press the button .
- (Water drains for up to 30 seconds
then the appliance switches off).
To change the program in progress:
- Press the button to cancel the program on running.
- (Water drains for up to 30 seconds then the appliance
switches off).
- Press any button to switch on the appliance.
- Select a new program.
- Press the
START
button.
Rectifying minor faults yourself ...
10
9
Filter
Check and
clean if
necessary
Unscrew filter
cylinder,
remove it and
fine sieve...
Rinse under
running water...
Screw on filter cylinder
NOTE MARK!
Unscrew
and remove
upper arm...
Spray
arms
Remove
blockages/
deposits.
Insert
Clean spray
nozzles under
running water
(use toothpicks
if necessary)...
Insert and screw on lower and upper arms tightly.
Unscrew
and remove
lower arm...