Quick Start Guide

ManualsBrandsWhirlpool ManualsDishwasherADG 9415

5019 396 91628

ADG 9415

Quick Reference Guide

Before using the dishwasher, read the user instructions!

WH/I/FD/GB

(We reserve the right to make technical modifications)

Whirlpool is a registered trademark of Whirlpool USA

Add regeneration salt

Only add regeneration salt immediately

before starting a wash programme.

1) Reference programme for energy label EN 50242;

2) Refer to “User instructions”;

3) Programme data obtained in conformity with European

standard EN 50242. Values may vary in relation to usage,

e.g.: different loads, options, water temperatures - above

or below 15°C - as well as water hardness and power

supply voltage, etc.

4) The bacteria removal efficiency has been tested by the

Institut Pasteur de Lille (France), based on the NF

EN 13697 standard of November 2001.

5) Programme interruption (e.g. the door being opened)

may compromise the result of the antibacterial rinse.

6) Energy saving programme with prolonged drying cycle.

On button

Off button

Programme selection button

Start button

Switches “on” when the dishwasher is

operating. Flashes when a fault occurs.

Switches off at the end of the programme.

Indicators

Programme chart

Detergent

Consumption

Programmes Loading instructions A B

Litres kWh Minutes

Pre-Rinse cold

Crockery to be washed later. - - 5.0 0.02 10

Quickwash 40°C

Lightly soiled crockery with no

dried-on food.

X - 13.0 0.70 30

Eco

1) 6)

50°C

Normally soiled crockery. X X 16.0 1.05 195

Intensive 70°C

Recommended programme for

heavily soiled crockery, especially

suitable for pans and saucepans.

X X 17.0 1.65 145

Important information for Test Laboratories:

For detailed information on the EN comparison test and other tests, contact the following address:

“nk_customer@whirlpool.com”.

Summary of content (4 pages)

PAGE 1
Before using the dishwasher, read the user instructions! GB Quick Reference Guide ADG 9415 On button Off button Programme selection button Start button Switches “on” when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme. Indicators Add regeneration salt Only add regeneration salt immediately before starting a wash programme.
PAGE 2
How to use the appliance Further indications are given in the single chapters and in the user instructions. Open the door, switch on the appliance How to fill the detergent dispenser Press the ON button. Compartment A: With each wash cycle. Compartment B: For programmes with pre-wash only. If using combined action dishwasher tabs, follow the user instructions! A Check the rinse aid level Mechanical indicator C. Electric indicator on control panel (if provided).
PAGE 3
Dishwasher loading instructions and racks provided Upper rack: depending on the model Multi-purpose support (A): 1) Depending on the position, for longhandles utensils, cups and glasses. May be used in three different positions. Crockery holders (B): Depending on the position, for example plates, cups and long-stemmed glasses. Revolving glass support (C): 2) Depending on the position, for example small or long-stemmed glasses. Long-handled utensils (e.g.
PAGE 4
What to do if... If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see also the corresponding chapter in the user instructions). Problem The appliance is not working If crockery is not perfectly dry If crockery is not perfectly clean Cause Remedy • No water supply. • Open the tap. • The appliance does not load sufficient water. • Clean the water supply tap filter. • Ensure there are no kinks in the water hose.