Instruction for Use

ManualsBrandsWhirlpool ManualsDomestic AppliancesACM804BA

EN12

TROUBLESHOOTING GUIDE

• Read and follow the instructions given in the section “Instructions for use”.

• Check that the electricity supply has not been shut off.

• Dry the hob thoroughly after cleaning it.

• If, when the hob is switched on, alphanumeric codes appear on the display, consult the following table for instructions.

• If the hob cannot be switched off after using it, disconnect it from the power supply.

ERROR CODE DESCRIPTION POSSIBLE CAUSES ERROR ELIMINATION

C81, C82

The control panel switches o because

of excessively high temperatures

The internal temperature of electronic

parts is too high

Wait for the hob to cool down before

using it again

C83

The control panel indicates the error code

hob o because of an issue on electronic

circuit

Cooktop has been supplied with over

voltage

Cooktop may be still used but call

the After-Sales Service

C85 Hob is not able to give power to the pot Pot is not suitable to the induction hob Use another induction pot

F02 or F04 or C84

The connection voltage is wrong or issue

to the power supply

The sensor detects a discrepancy

between the appliance voltage and

that of the mains supply

Disconnect the hob from the

mains and check the electrical

connection

F01, F05, F06, F07, F10, F12, F25, F33,

F34, F36, F37, F46, F47, F48, F49, F58,

F61, F62, F63, F72, F74, F77

Disconnect the hob from the power supply.

Wait a few seconds and plug it again.

If the problem persists, call the After-Sales Service and specify the error code.

NOISES MADE BY THE HOB

The induction cooktops can generate a set of noise and vibration during normal operation, depending on the type of material and the processing of the food,

such as those described below:

• Noise contact: this type of vibration is due to the use of pots made of different materials superimposed.

• Sounds click at mid-lower power: this noise is produced in order to achieve the low-mid power required.

• Sounds like rhythmic click: this noise is produced when operating several areas of cooking and / or high performance.

• Hissing weak: this noise is due to the type of container used and the quantity of food contained.

• Background noise: the induction cooker is equipped with a fan aimed at cooling the electronic components and for this reason during operation and also for a few minutes

after switching off the hob you hear the noise of the fan. Increase / decrease the cooking zones activated, the background noise of the fan may increase or decrease.

These conditions are normal and essential for the proper functioning of the induction system, they are not indication of failure or damage.

AFTER-SALES SERVICE

Before contacting the After-sales Service:

1. See if you can solve the problem yourself with the help of the “Troubleshooting guide”.

2. Switch the appliance off and then on again it to see if the problem has been eliminated.

If the problem persists after the above checks, contact the nearest After-Sales Service.

Always specify:

• a brief description of the fault;

• the product type and exact model;

• the serial number located under the appliance, also available in the attached technical documentation.

• your full address;

• your telephone number.

If any repairs are required, contact an authorised After-Sales Service Centre (to ensure the use of original spare parts and correct repairs). Spare parts are available for 10 years.

ESEN FRIT

400011197363

10/17

HU PLRO