Instruction for Use
27
INSTRUCTIONS FOR THE INSTALLER
REPLACING THE TAPS (g. 18)
To change a tap proceed as follows:
• Remove pan supports, burner heads and
knobs.
• Unscrew the burners securing screws.
• Remove the lateral sides, lid and hob.
• Unscrew the check nuts of rails (D) and/or of
any thermocouples and remove tap (R) by
unscrewing the screws (V).
• Partly remove the burners small supply pipes
and change the relative part.
• Replace the seal (G) each time you change a
tap so as to guarantee a perfect t between
body and rail.
• Reassemble all the parts following the same
procedure but in the reverse order.
REPLACING THE ELECTRICAL COMPONENTS
• The rear protection will have to be removed
in order to change the electrical heating
elements, lamp holder, terminal board and
power cable.
• If you have to change the power cable,
always keep the earth wire longer than
the phase wires and, in addition, follow all
the instructions given in the “ELECTRICAL
CONNECTION”.
• To change the oven lamp see the instructions
given in the «REPLACING THE OVEN LAMP».
• To change lamp holder (P), remove the side
panels and then use a screwdriver to push
the two locking tabs (M) (g. 19) and remove
the lamp holder from the inside of the oven.
• To replace the ignition generator, remove the
left side panel of the appliance.
• To change the thermostat, commutators or
hob heating elements, the work top has to
be removed.
18
19