Instruction for Use

EN 66
ELECTRICAL CONNECTION
WARNING
• Disconnect the appliance from the power supply.
• Installation must be carried out by qualied personnel who know the current safety and installation regulations.
• The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from
failure to observe the regulations provided in this chapter.
• The power cable must be long enough to allow the hob to be removed from the worktop.
• Make sure the voltage specied on the dataplate located on the bottom of the appliance is the same as that of
the home.
• Do not use extension cords.
Connection to the terminal block
If the hob is already provided with the two power supply cables required, follow the instructions included in the supply cable bag.
Connect the cables to the two terminal blocks on the underside of the appliance.
IMPORTANT: only for 400 V 3N connection~ use one power supply cable only (connecting it to the terminal block of the main electronic module) in addition to
3 x 1.5 mm
2
wiring for connecting the main terminal block to that of the auxiliary electronic module. For electrical connection, follow the instructions enclosed
with the 3 x 1.5 mm
2
wiring.
3 x 1.5 mm
2
400 V 3N ~ 230 V ~ / 230-240 V ~ / 400 V 2N ~ / 230 V 3 ~
For the electrical connection, use an H05RR-F cable as specied in the table below.
WiresNumber x size
220-240 V ~ +
3 x 4 mm
2
230 V 3 ~ +
5 x 1,5 mm
2
380-415 V 3N ~ +
5 x 1,5 mm
2
380-415 V 2N ~ +
4 x 1,5 mm
2
230 V
230 V
230 V
230 V
230 V 230 V
230 V 230 V
230 V
230 V 230 V
400 V 3N ~230 V ~
230-240 V ~
(Australia only)
230 V ~ (UK only)
400 V 2N ~ 230 V 3 ~ (Belgium only) 400 V 2N ~ (NL only)
CBA