Installation guide

Put dishwasher on its back
Helpful Tip: Place cardboard under dishwasher until installed in
cabinet opening to avoid damaging floor covering. Do not use
door panel as a worktable without first covering with a towel to
avoid scratching the door panel.
Using 2 or more people, grasp sides of dishwasher door frame
and place dishwasher on its back.
NOTES:
m Stainless steel tub models have a plastic rail cover installed on
each side of the dishwasher frame.
If you have a stainless steel tub model, complete Step 3.
mw If you have a plastic tub model, proceed to Step 4.
3 | Remove plastic rail cover
Plastic rail
cover
o.
9
Remove and discard the plastic rail cover on each side of the
dishwasher frame. To remove the plastic rail cover, push upward
and back to unsnap it from the dishwasher frame.
4 | Remove panel and fasteners
Unlocked
Using a flat-blade screwdriver, turn the plastic fasteners % turn to
unlock them. Remove panel. Do not remove tech sheet from
access panel.
5 Remove terminal box cover
Using a 4" hex head socket, nut driver or Torx T20 screwdriver,
remove terminal box cover. Retain for later use.
6 Install strain relie
Nv
Install a UL Listed/CSA Approved strain relief. Make sure screw
heads are facing to the left when tightening conduit nut. Strain
relief is provided with the power supply cord kit.
What type of electrical
connection will you use?
~ Power Supply Cord:
Follow Option A instructions
Direct Wire:
Follow Option B instructions
NOTE: If using Option B, proceed to “Determine Cabinet
Opening,” to continue with the installation of your dishwasher.