Ventilation Hood User Manual

ManualsBrandsWhirlpool ManualsVentilation Hood36"

Install Range Hood Liner

The hood liner attaches to the hood support using four mounting

screws and washers.

NOTE: Hood support must be capable of supporting

75 lb (34 kg).

1. Using 2 or more people, lift the hood liner into place.

2. Install the hood liner using four 5 x 45 mm screws to the hood

support and tighten securely.

Install Hood Liner Internal Blower Motor

NOTE: Your hood liner requires you to purchase either an internal

type or an in-line (external type) blower motor system. See

“Blower Motor System” in the “Accessories” section.

The internal blower system can be mounted for top venting or

rear venting. For top venting, the mounting bracket and spring

clip that come with the blower system will mount to the top panel

of the hood liner. For rear venting, the mounting bracket and

spring clip that come with the blower system will mount to the

rear panel of the hood liner.

Prepare the Internal Blower System

IMPORTANT: Perform steps 1-4 before mounting the hood liner.

1. Remove grease filters from hood liner. See the “Range Hood

Care” section in the Use and Care Guide.

2. Install the motor support bracket using three 4.2 x 8 mm

screws. Screw bracket to the inside top or back (alternate

location on some models), toward the left side of the hood

liner.

3. Install motor spring clip using two 4.2 x 8 mm screws. Screw

spring clip to the inside top or back (alternate location on

some models) of the hood liner at the proper location for the

selected motor system. Slide the mounting tab of the spring

clip through the slot in the panel and secure with the screws.

Use the inside set of mounting holes for the single motor

system. Use the outside set of mounting holes for the dual

motor system.

4. Install the 6 mm nuts to the outside top or outside back

(alternate location on some models) of the hood liner at the

proper location for the selected motor system.

■ Two 6 mm nuts are required for the single motor system.

Clip nuts into the small square notches located at the left

and right end of the square vent opening.

■ Five 6 mm nuts are required for the dual motor system.

Clip nuts into the small square notches, one located in the

front of the square vent opening and the other four

located at the left and right ends of the square vent

opening.

5. Mount hood liner. See the “Install Range Hood Liner” section.

A. 4.2 x 8 mm screws (3) for motor support bracket

B. 4.2 x 8 mm screws (2) for motor spring clip

C. Motor support bracket

D. Motor spring clip (single motor assembly location)

E. Motor spring clip (dual motor assembly location)

A. Clip nut (6 mm) locations for dual motor assembly (quantity 5)

B. Clip nut (6 mm) locations for single motor assembly (quantity 2)